User manual TEFAL OLEOCLEAN DELUXE

[. . . ] ⷠNever leave the appliance unattended : - when it is connected to the mains, - until it has cooled down (around 1 hour). ⷠThe soleplate and generator iron-rest can become very hot and cause burns: never touch these parts. ⷠYour appliance gives off steam which can cause burns. Handle your iron carefully, particularly when using the vertical steam function. [. . . ] To transport your steam generator using the handle of the iron : - place the iron in position on the housing plate on the steam generator and fold the ring over the iron until it locks into position (you will hear a "click") - fig. ⷠYour iron has been designed to operate using untreated tap water. ⷠHeat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your iron. Ironing Boards: Due to the powerful steam output, a mesh type ironing board must be used to allow any excess steam to escape and to avoid steam venting. If your water is very hard (check with your local water authority) it is possible to mix untreated tap water with store-bought distilled or demineralised water in the following proportions : 50% untreated tap water, 50% distilled or demineralised water. Your iron is equipped with an extension cord system to prevent the cord from dragging over Always use the Easycord the laundry and creasing it again when ironing. system for enhanced · Take the steam cord out of its housing and unwind it completely. When the cord outlet tips, the Easycord system extends automatically without you having to press the Eject button. The first time the appliance is used, there may be some fumes and smell but this is not harmful. ⷠCompletely unwind the power cord and the steam cord from its storage space. An orange "anti-scale" light located on the control panel starts blinking to tell you that the antiscale valve needs rinsing - fig. Important: This operation must not be carried out unless the steam generator has been unplugged for at least two hours and has cooled down completely. To carry out this operation, the steam generator must be close to a sink as water may come out of the tank when it is opened. ⷠOnce the steam generator has cooled down completely, remove the scale collector cover - fig. Unscrew the anti-scale valve and remove it from the housing; it contains the scale that has built up in the tank - fig. To clean the valve properly, just rinse it under running water to remove the scale it contains fig. Put the valve back into its housing and screw it in completely to keep it watertight - fig. The next time you use your iron, press the "restart" button on the control panel to turn off the orange "anti-scale" light. Raise the retaining hoop over the iron until it locks into place (audible click) - fig. Take the end of the cord support and press to return the flexible part into the base. Put the end of this loop in the slide storage place then push gently until you see the end on the other side of the slide storage place - fig. [. . . ] The steam generator does not switch on The appliance is not switched on. Water has condensed in the pipes because Press on the steam control button away you are using steam for the first time or you from your ironing board until the iron have not used it for some time. Decrease the steam output while ironing at low temperature (steam output control dial on the control panel). Wait for the thermostat light to go out before activating the steam control button. [. . . ]