User manual TEFAL PRO MINUTE PLUS

[. . . ] · The appliance must be used and placed on a stable, heat-resistant surface. When you place the iron on the iron rest, make sure that the surface on which you place it is stable. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Red light "water tank" on: the water tank is empty ­ fig. 9. Orange light "boiler rinse" flashes: rinse the boiler ­ fig. 11. Use Steam ironing · Place the iron's temperature control slide according to the type of fabric to be ironed (see table below). The steam generator is ready when the thermostat light goes out and when the green "steam ready" light stays on. · Adjust the steam output control dial (located on the control panel). · While ironing, the light on top of the iron and the steam ready light turn on and off, according to the heating needs without interrupting the use. · To obtain steam, press on the steam control button on top of the iron handle and keep it pressed ­ fig. 8. · When starting, and regularly while it is being used, your steam generator's electric pump injects water into the boiler. · Always spray starch onto the reverse side of the fabric to be ironed. Do not place the iron on a metal support. When taking a break from ironing, always place the iron on the iron rest plate of the unit. It is equipped with non-slip pads and has been designed to withstand high temperatures. Setting the temperature SETTING THE TEMPERATURE CONTROL SLIDE AND STEAM OUTPUT CONTROL DIAL ACCORDING TO TYPE OF FABRIC TO BE IRONED: Type of fabric Linen, Cotton Setting temperature control Setting steam output control dial ··· ·· Silk, Wool Synthetics, Polyester, Acetate, Acrylic, Polyamide · 4 To prime the steam circuit, · Iron temperature control slide setting: either before using the - Start with the fabrics to be ironed at a low temperature (·) and finish with those iron for the first time, or if which need higher temperatures (··· or Max). you have not used the - Mixed fibre fabric: set the ironing temperature to the setting for the most steam function for a few delicate fabric. minutes, press the - Woollen garments: press repeatedly on the steam control button to obtain short steam control button bursts of steam, without placing the iron on the garment itself. several times in a row, holding the iron away from · Steam output control dial setting: your clothes. any cold water to be ejected - At a low temperature : set the steam output control dial to the low position. from the steam circuit. GB Dry ironing · Do not press the steam control button on top of the iron handle. Refilling the water tank When the red "tank empty" indicator light turns on, there is no more steam ­ fig. 9. · Replace it fully into its housing until there is a click ­ fig. 6. · When the green light stops flashing, the steam is ready. Vertical steam ironing · Set the iron temperature control slide and the steam output control dial (located on the control panel) to the MAX position. · Hang the garment on a coat hanger and hold the fabric slightly taut with one hand. As steam is very hot : never attempt to remove creases from a garment while it is being worn, always hang garments on a coat hanger. [. . . ] Always spray starch on the reverse side of the fabric to be ironed. 7 PROBLEMS There is no steam or there is little steam. CAUSES The removable water tank is empty (red light on). The steam output control dial is set at minimum. SOLUTIONS Fill the removable water tank. Check that the water tank is pushed firmly into place until there is a "click". [. . . ]