User manual TOYOTA TUNDRA-2005

[. . . ] '05 TUNDRA_U (L/O 0409) Foreword Welcome to the growing group of value- conscious people who drive Toyotas. We are proud of the advanced engineering and quality construction of each vehicle we build. Please read it thoroughly and have all the occupants follow the instructions carefully. Doing so will help you enjoy many years of safe and trouble- free motoring. [. . . ] If the electrical power source has been disconnected from the clock, the time display will automatically be set to 1:00 (one o'clock). When the instrument panel lights are turned on, the brightness of the time indication will be reduced. Cigarette lighter and front ashtray CAUTION A When doing the circling calibration, be sure to secure a wide space, and watch out for people and vehicles in the neighborhood. Do not violate any local traffic rules while performing circling calibration. A Do not adjust the display while the vehicle is moving. Be sure to adjust the display only when the vehicle is stopped. Rear ashtray 318 2005 TUNDRA from Sep. (OM34432U) '05 TUNDRA_U (L/O 0409) Power outlets (12 VDC) CIGARETTE LIGHTER To use the cigarette lighter, press it in. After it finishes heating up, it automatically pops out ready for use. When finished with your cigarette, thoroughly extinguish it in the ashtray to prevent other cigarette butts from catching fire. Front--To remove the ashtray, press down on the lock spring plate and pull out. Rear--To remove the ashtray, pull it out. Type A Type C CAUTION To reduce the chance of injury in case of an accident or sudden stop while driving, always completely close the ashtray after use. Type B Type D 319 2005 TUNDRA from Sep. (OM34432U) '05 TUNDRA_U (L/O 0409) Power outlet (115 VAC) NOTICE z To prevent the fuse from being blown, do not use the electricity over the total vehicle capacity of 12V/120W. z To prevent the battery from being discharged, do not use the power outlets longer than necessary when the engine is not running. Inserting anything other than an appropriate plug that fits the outlet, or allowing any liquid to get into the outlet may cause electrical failure or short circuits. Type E The power outlets (12 VDC) are designed for power supply for car accessories. This power outlet (115 VAC) is designed for use as a power supply for electric appliances in the vehicle. The key must be in the "ON" position for the power outlet to be used. If you attempt to use an appliance that requires more than 115 VAC or 100W, the protection circuit will activate and cut the power supply. The power supply will restart automatically when you use an appliance that operates within the 115 VAC/100W limits. 320 2005 TUNDRA from Sep. (OM34432U) '05 TUNDRA_U (L/O 0409) NOTICE z To prevent the battery from being discharged, do not use the power outlet longer than necessary when the engine is not running. Inserting anything other than an appropriate plug that fits the outlet may cause electrical failure or short circuits. The power outlet is not designed for the following electric appliances even though their power consumption is under 115 VAC/100W. These appliances may not operate properly. Certain electrical appliances may cause radio noise. Main switch To use the power outlet, push the main switch on the instrument panel. An indicator light will illuminate to indicate that the power outlet is ready for use. When the power outlet is not in use, make sure that the main switch is turned off. A Appliances with high initial peak wattage: cathode- ray tube type televisions, compressor- driven refrigerators, electric pumps, electric tools, etc. A Measuring devices which process precise data: medical equipment, measuring instruments, etc. A Other appliances requiring an extremely stable power supply: microcomputercontrolled electric blankets, touch sensor lamps, etc. 321 2005 TUNDRA from Sep. (OM34432U) '05 TUNDRA_U (L/O 0409) Glove box Garage door opener box To use the glove box, do this. [. . . ] If you discover any leakage, have it repaired by a qualified technician immediately. Drive Belts Inspect for cracks, excessive wear and oiliness. Replace the belts if they are damaged. Drive Shaft Boots Check the drive shaft boots and clamps for cracks, deterioration and damage. Replace any deteriorated or damaged parts and, if necessary, repack the grease. Selected models also require periodic inspection of the drive shaft bolt for proper torque. [. . . ]