User manual TP-LINK TD-W8960N

[. . . ] TD-W8960N Wireless N ADSL2+ Modem Router Rev: 1. 0. 0 1910010174 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. http://www. tp-link. com FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] Add: Click the Add button, and then you can add a new MAC Filter in the next screen (shown in Figure 4-34). Remove: Select the check box in the table (shown in Figure 4-34) and then click the Remove button, and then the corresponding entry will be deleted in the table. Click the Add button (pop-up Figure 4-34), and you will set the new rule in the next screen (shown in Figure 4-35). 40 TD-W8960N Wireless N ADSL2+ Modem Router User Guide Figure 4-35 2. Click Save/Apply to save this entry. 4. 4. 7 Parental Control Choose "Advanced Setup" "Parental Control". You can configure the Parental Control rules on the screen (shown in Figure 4-37). This function allows you control the internet activities of the child, limit the child to access certain websites and restrict the time of surfing. Figure 4-36 4. 4. 7. 1 Time Restriction This section allows you add time of day restriction to a special LAN device connected to the Router. 41 TD-W8960N Wireless N ADSL2+ Modem Router User Guide Figure 4-37 To add a Time Restriction entry for Parental Control rule: 1. Click the Add button (pop-up Figure 4-37), and then you will set the new rule in the next screen (shown in Figure 4-38). Figure 4-38 2. To restrict the device where the browser is running, select the Browser's MAC Address radio-button, its MAC Address has automatically displayed in the text box. To restrict other LAN devices, click the Other MAC Address radio-button and enter the MAC address of the other LAN device. Enter the Start Blocking Time and End Blocking Time in the text box separately, and then the device controlled will then be unable to connect to the internet during that time. 6. 42 TD-W8960N 4. 4. 7. 2 URL Filter Wireless N ADSL2+ Modem Router User Guide This section allows you to configure the filter rules based on URL to control the computers in the LAN to access the specified port. Figure 4-39 There are two policies for the URL Filter. Click the Add button and then you will set the new rule in the next screen. Figure 4-40 2. Click Save/Apply to save this entry. Figure 4-41 43 TD-W8960N Wireless N ADSL2+ Modem Router User Guide 4. 4. 8 Quality of Service Choose "Advanced Setup" "Quality of Service", you can enable QoS (Quality of Service) on the screen (shown in Figure 4-42). By attaching special identification marks or headers to incoming packets, QoS determines which queue the packets enter, based priority. This is useful when there are certain types of data you want to give higher priority, such as voice data packets give higher priority than Web data packets. This option will provide better service of selected network traffic over various technologies. Figure 4-42 Select the Enable QoS checkbox to enable all QoS for all interfaces. Select a default DSCP make from drop-down list to automatically mark incoming traffic without reference to a particular classifier. Note: The default DSCP mark is used to mark all egress packets that do not match any classification rules. 4. 4. 8. 1 Queue Config Choose "Advanced Setup" "Quality of Service" "Queue Config", you can set up virtual servers on the screen below. Figure 4-43 44 TD-W8960N Wireless N ADSL2+ Modem Router User Guide Click the Add button, and you can configure the QoS queue entry on the next screen (shown in Figure 4-44). Figure 4-44 Name: Set a name for the entry. DSL Latency: Select latency path for the type of data transmission, only Path0 is available for this Router. Note: 1) 2) Lower integer values for precedence imply higher priority for this queue relative to others. The queue entry configured here will be used by the classifier to place ingress packets appropriately. 4. 4. 8. 2 QoS Classification This section will guide you to create a traffic class rule to classify the upstream traffic, assign queue which defines the precedence and the interface and optionally overwrite the IP header DSCP byte. [. . . ] The transport independence of RPC isolates the application from the physical and logical elements of the data communications mechanism and allows the application to use a variety of transports. Server - Any computer whose function in a network is to provide user access to files, printing, communications, and other services. SOHO (Small Office/Home Office) - Market segment of professionals who work at home or in small offices. SSID - A Service Set Identification is a thirty-two character (maximum) alphanumeric key identifying a wireless local area network. [. . . ]