User manual TP-LINK TM-IA5629V INSTALLATION GUIDE

[. . . ] TM-IP5600/TM-IA5629V INTERNAL 56K MODEM Rev: 1. 0. 0 1910010022 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. [. . . ] Operation is subject to the following two conditions: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. Package Contents The following contents should be found in your package: One Internal Modem One User's Guide One RJ11 Cable One Resource CD , including: · This User Guide · Other Helpful Information Note: Make sure that the package contains the above items. If any of the listed items are damaged or missing, please contact with your distributor. CONTENTS Chapter1 Chapter2 Chapter3 Chapter4 Chapter5 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Feature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Hardware Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Software Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Dial for connection to Internet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Chapter1 Introduction Thank you for choosing the TP-LINK internal Modem for your personal computer. Now you can experience the high quality of communication products for your computer application. This manual provides the operating instruction for user installation procedures. If you encounter any problem during the installation or using your modem that cannot be solved with the help of this manual, please do not hesitate to contact your dealer for technical support. Chapter2 Feature Data Modem Communication Protocol: ITU-T V. 92/V. 90, 56Kbps ITU-T V. 34, 33600 to 2400 bit/s ITU-T V. 32bis, V. 32 ITU-T V. 22bis, V. 22 ITU-T V. 23, V. 21 Bell 212A, 103 Fax Protocol: ITU-T V. 17, V. 29, V. 27ter, and V. 21 Channel 2 TIA/EIA 578 class 1 FAX, Fax Speed High to 14400bps Voice: Voice/Audio Mode Speaker/MIC jack Data Correct: V. 42 LAPM and MNP2-4 Data Compression: V. 44/V. 42 bis and MNP5 Command System: EIA/TIA 578 Class 1 Concurrently Hays AT Command Operating System Support: Windows 98, Windows ME, Windows2000, and Windows XP Flow Control: XON/XOFF or RTS/CTS Protect Circuit: Internal arrester circuit V. 92 and V. 44 New Features: Modem On Hold Quick Connect PCM UP Stream V. 44 Data Compression Note: V. 92 and V. 44 function need network support. 1 Chapter3 Hardware Installation The basic steps for hardware installation is as following; 1) Turn off your computer. 2) Put off the metal cover on the PCI bus slot which you would like to install the modem. 3) Plug the internal modem, fasten the modem after confirming you have plugged well. If you want to use a telephone on the same line, use the RJ11 cable attached to connect the telephone to the PHONE port of the Modem. Chapter4 Software Installation Assuming your system is windows 2000, other windows system is similar. [. . . ] a) b) c) d) e) f) Go into Control Panel\Network and Dial-up Connections, double-click New connection, click Next. You can also click the Property in the Connection dialog box to set other configurations. 2 [. . . ]