User manual UNIVERSAL REMOTE CONTROL CRICKET KIDS REMOTE CONTROL

[. . . ] Find your TV brand and enter the first code for that brand by using the number keys on the remote. When you press the fourth number key, the LED on the remote blinks twice to confirm a valid code. Slide the switch on the back of the remote to CHILD mode. To test the new TV code: 3. 4. 5. Point the remote at the TV and press MUTE. NOTE: 7. If MUTE did not work, repeat the SET TV Control process until the TV responds to MUTE. [. . . ] When in programming mode, VOL + initiates programming for TV and VOL initiates programming for cable. CHILD MODE: CH and CH cycles through the ten programmed kids channels on the remote. ADULT MODE: CH and CH cycles the cable box through ALL cable channels. PROGRAMMING MODE: CH and CH cycles through codes to set control of your television or cable box. The eight pre-programmed keys with children network icons jump directly to the channel associated with the icon when in Child mode or Adult mode. While in programming mode, these keys act as number keys 3-0 for programming favorite channels. The three-position switch in the battery compartment is used to set the user or programming mode. CHILD mode is for children and limits them to only have access to the ten programmed channels on the remote. ADULT mode is for older kids or adults and allows access to all cable channels when using channel up/down. P is Programming mode and is used while setting up the remote control to control the TV, Cable box, and to add or modify favorite channels. www. urcsupport. com/cricket 8 Kids Remote 2006. fm Page 9 Tuesday, March 6, 2007 3:52 PM ADDITIONAL PROGRAMMING OPTIONS Locate the three position switch within the battery compartment. When programming is complete, set the switch to either CHILD user mode or ADULT user mode before replacing the battery compartment door. SETTING TV CONTROL TV control can be set by inputting the code for your brand of TV or via a simple code search. Setting TV control by code input is described in the Quick Start on page 4. With your television ON, and the remote in Programming mode, press the CH key. If the TV does not turn on, press CH to go to the previous TV code and press MUTE to save once the TV turns on. NOTE: There are over 200 possible codes, so this may take a few minutes. RE-PROGRAMMING FAVORITE CHANNEL KEYS Cricket comes pre-programmed with 8 favorite kids channels assigned to keys 3 through 0. The preprogrammed buttons can be programmed to new channels by following the steps below. CAUTION: This will program over the channel that was pre-programmed by your cable provider!While in Programming mode, press and hold the key that you wish to assign a favorite channel. Press the digits for the channel number for the favorite channel that you wish to add. Press and hold the key that you wish to assign again until the LED blinks twice. www. urcsupport. com/cricket 9 Kids Remote 2006. fm Page 10 Tuesday, March 6, 2007 3:52 PM 4. [. . . ] While in CHILD or ADULT mode, hold down both MUTE and ON/OFF for three seconds, until the LED blinks twice. Enter the first code for that brand with the number keys on the remote. When you press the fourth number key, the LED on the remote blinks twice to confirm a valid code. If the channel does NOT change, repeat steps 1 through 3 for the next code for that brand of set-top-box. [. . . ]