User manual UNIVERSAL REMOTE CONTROL MSC-400

[. . . ] MSC-400 System Quick Reference Guide Power LED indicates that the MSC-400 is powered on. USB 1 LED indicates that the USB Programming Port (Front Panel USB) is connected to a PC. MSC-400 Master System Controller Front Panel Learning Sensor for learning IR commands. [. . . ] Warning Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. Note : The manufacturer is not responsible for any Radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. NOTE: MSC Editor Software is not included with the MSC-400. If you have not registered yet, call your distributor or sales representative for a registration code and use the Dealer Login at: www. universalremote. com Sensor LEDs light when a Sensor is sensing that a component is ON (Video is present or Voltage is high). Front Panel USB port is used ONLY for PROGRAMMING RFX-250 Narrow Band RF Receiver Front Panel 45° Start with the antenna angle set to 45 degrees and positioned so that the long side of the antenna is facing the customer's favorite seating position. Once the RFX-250 is correctly connected, the POWER LED lights. If the RF LED lights, the RFX250 must be moved to a new mounting location. It is receiving in-band RF INTERFERENCE. Front Views - Flip for Rear Views MSC-400 System Quick Reference Guide MSC-400 Master System Controller Rear Panel IR and RS232 Outputs For RS-232: Connect to Outputs 7-12 only. Order either RS232M (Male connector for component) or RS232F (Female connector for component). Standard emitters can be used on 1-6, sleeved emitters should be used for Outputs 7-12. Control the IR output level via the adjustment screws on the top panel. Standard Emitter for Outputs 1-6 (can be used temporarily in Outputs 712). RS-232 Connector for Outputs 7-12 Order RS232M (Male DB9 connector for component) or RS232F (Female DB-9 connector for component). USB2 Keyboard Port This port allows keyboard control of a PC. USB1 on the front panel is used for programming the MSC-400. Video or Voltage Sensor Inputs Sense video via the VID-6 Video sensor (six to a box) or sense a 3-25 V AC or DC voltage via the VS-100 Voltage Sensor (six to a box). The VS-100 Voltage Sensor is necessary when using other manufacturer's current, light or RF sensors. No video or voltage sensors are included with the MSC-400. IR Input This port enables an IR Keypad or connecting block to route IR signals to all emitters. RF Input This port connects to up to three RFX-250s in parallel. RF Output This port connects to other MRF or MSC units in the same location. Relays 1 and 2 Each relay is compatible with Low Voltage applications (less than 30V with no more than . 5 amps maximum current). The relay can be programmed to Open, Close or Toggle it's state in three ways: 1. [. . . ] MSC-400 Rear View Note that 5V and GND positions are different on the RFX-250 compared to the MSC-400. The Data connects to Data, 5 V connects to 5V and GND connects to GND. Rear Views - Flip for Front Views [. . . ]