User manual UNIVERSAL REMOTE CONTROL MX-600

[. . . ] Programming Macro Functions To M1, M2, M3, POWER ON and POWER OFF Buttons B. Introduction Thank you for purchasing the MX-600 RF/IR remote control. You can use the MX-600 line of sight with your components via IR (infrared) and/or with the companion MRF-100 base station. The base station will enable you to place your audio/video components out of sight behind closed doors and/or in another room of your house. [. . . ] Programming Macro Functions To M1, M2, M3, POWER ON And POWER OFF Buttons 1. Go to the SETUP mode by pressing the MAIN and ENTER button simultaneously for three seconds. Press one of the macro buttons, M1-M3, POWER ON or POWER OFF you wish to store your macro on. 4. Press the functional buttons you wish to store in the device macro button you selected, in the order you want them stored. Important: Do not press the MAIN button at the beginning of your macro, or it will not work. Be sure to end your macro on the Device page that you would like it to remain on when the macro is sent in normal use. Store the commands you programmed into the macro button by pressing the Channel Up button. Return to Step #3 until you have programmed all of the Macros that you require. Once you have completed the programming and wish to exit from this mode, press the MAIN button. Tip: The M1, M2, M3, POWER ON and POWER OFF macros are "system-wide", meaning they will function the same no matter what device you are in when you use them. 27 7. Go to the SETUP mode by pressing the MAIN and ENTER buttons simultaneously for three seconds. Press the functional buttons you wish to store in the device macro button you selected in the order you want them stored. Important: Do not press the MAIN button at the beginning of your macro, or it will not work. Be sure to end your macro on the Device page that you would like it to remain on when the macro is sent in normal use. Save the commands you selected to the macro button by pressing the CH UP button. Return to Step #4 until you have programmed all of the Macros that you require. Once you complete the programming and wish to exit from this mode, press the MAIN button. Exit from the SET UP mode by pressing the MAIN button once again. 28 7. Programming Macro Buttons Tip: Remember that a single push of a Device Button that has a macro connected to it will take you to that device's function pages. You will need to hold the Device Button down for 1 second in order to send out the macro that you have created for that Device Button. Tip: Pressing the PAUSE button (the key to the bottom right of the cursor pad) during the macro programming will add a time delay of 0. 2 seconds between the commands. For example, pressing the PAUSE button three times will create a pause of 0. 6 seconds between the commands where the delay was inserted. [. . . ] The database used for the preprogrammed Device codes may not be able to control all your devices. In this case you can simply use the learning capabilities of the remote. Punch Through: A term coined to represent the ability to use certain functions from one device under another. For instance, when a remote is set to the "Television" device, the transport keys may be "punched through" to operate the 50 18. [. . . ]