User manual UNIVERSAL REMOTE CONTROL ONE FOR ALL 7800CMN

[. . . ] Press and hold SETUP until the red light blinks twice, then release SETUP. If you perform this procedure correctly, the red light will blink twice when entering the final digit. If your original VCR remote control did not have a POWER key, press STOP. If your VCR does not respond, repeat steps 2-4, trying each code listed for your brand until you find the one that operates your VCR. [. . . ] TV/VCRs working on VCR code 0035 may require TV code 0051 for volume control. TV/VCRs working on VCR code 0048 may require TV code 0093 for volume control. TV/VCRs working on VCR code 0060 may require TV code 0047 for volume control. TV/VCRs working on VCR code 0081 may require TV code 0054 for volume control. TV/VCRs working on VCR code 0162 may require TV code 0250 for volume control. TV/VCRs working on VCR code 0278 may require TV code 0451 for volume control. 3. 4. Programming the Cinema 7+TM to operate your DVD or Laser Disc Player: Locate the brand name of your DVD or Laser Disc Player in the DVD or Laser Disc Player setup codes (starting below), and write it in the space below. DVD/LD Player Brand: ______________________ The brands are listed in alphabetical order with the most popular codes listed first. You will use one of these codes to program your Cinema 7+TM to operate your DVD or Laser Disc Player as follows: 1. Press and hold SETUP until the Cinema 7+TM's red light blinks twice, then release SETUP. Enter the first four-digit DVD or Laser Disc Player code listed for your brand. If performed correctly, the red light will blink twice when entering the final digit. If it does not respond, repeat steps 2-4, trying each code listed for your brand until you find the one that works. NOTE: If you have tried all the codes listed for your brand and your DVD or Laser Disc Player does not respond, try using the search method found on page 22. Your Cinema 7+TM is now programmed to operate your DVD or Laser Disc Player. Write your DVD or Laser Disc Player code in the boxes to the left for future reference. Denon Mitsubishi NAD Pioneer Sony 0059 0059 0059 0059 0193, 0201 Programming the Cinema 7+TM to operate your Receiver/Tuner: Locate the brand name of your Receiver/Tuner in the "Setup Codes For Receiver/Tuners" section (starting below), and write it in below. Receiver/Tuner Brand: ______________________ The brands are listed in alphabetical order with the most popular codes listed first. You will use one of these codes to program your Cinema 7+TM to operate your Receiver/Tuner as follows: 1. Press and hold SETUP until the Cinema 7+TM's red light blinks twice, then release SETUP. Enter the first four-digit Receiver/Tuner code listed for your brand in the "Setup Codes For Receivers/Tuners" section. If performed correctly, the red light will blink twice when you enter the final digit. [. . . ] Aim the Cinema 7+TM at your Cable Converter or Satellite Receiver and press POWER. If it does not respond, repeat steps 2-4, trying each code listed for your brand until you find the one that operates your Cable Converter or Satellite Receiver. NOTE: If you have tried all the codes listed for your brand and your Cable Converter or Sateliite Receiver does not respond, try using the search method found on page 22. Your Cinema 7+TM is now programmed to operate your Cable Converter or Satellite Receiver. [. . . ]