User manual UNIVERSAL REMOTE CONTROL R7

[. . . ] If any of the functions do not work as they should, repeat from Step 2 using the next three-digit code number from the same brand list. STEP4 Press the same [COMPONENT] button to store the code. The component LED light will blink twice to confirm that the code has been stored. *Note : The [AUX] LED light will blink once for each button pressed. If the component does not turn off, press the next code numbers listed for your brand until the component turns off. [. . . ] The component LED light will blink twice to confirm that the code has been stored. *Note : Now turn on the component and test the component functions on the remote control. If any function does not work properly, repeat from STEP 2 using the next code number listed for your component brand until you find a perfect match. F. Programming Channel Control. By following the steps below, the user can program the channel controls (Channel Up, Channel Down and Last) from one component to operate in another component mode. The default channel control settings on the remote control is as follows: STB : STB TV : STB VCR : VCR AUX : AUX If you wish to store the TV channel control in TV mode, use the following steps. STEP1 Press the [TV] button and the [OK] button simultaneously for 3 seconds until the TV LED light turns on. *Tip : If you do not press the [VOL-] button within 20 seconds, the TV LED light will tiurn off and exit set-up mode and you will need to start over. To return to the original default state: If you wish to restore the STB channel control in TV mode, repeat the above steps by pressing [STB] in STEP3 . C. To Find the Three-Digit Code Number That was Stored in the component. STEP1 Press the [COMPONENT] button (TV, VCR, DVD or AUX) you wish to verify and the [OK] button simultaneously for 3 seconds. Programming AUX to operate a fourth component (i. e. , a second TV, VCR, or DVD or AUDIO) STEP1 Turn on the component you wish to operate. STEP2 Press the [AUX] button and the [OK] button simultaneously for 3 seconds. *Tip : If you do not press the desired component button within 20 seconds, the [AUX] LED light will turn off and exit set-up mode and you will need to start over. STEP4 Point the remote control toward the component you want to program and enter the three-digit code number assigned to your TV brand from the code tables. G. Low Battery Warning. When the battery is low and needs to be replaced with fresh batteries, the remote control component LED lights will blink 2 times in sequence whenever a [POWER] button is pressed to turn on components 4 Operations Device Default: PalAmino4 Set-Top Box. Volume Default: TV volume and mute through the TV , with the option of controlling volume and mute through the STB or AUDIO component. Refer to section E for programming the volume and mute through your STB or AUDIO component. Channel Default: STB channel and number keys through the STB, with the option of controlling channel and number keys through the TV or VCR. Refer to section F for programming the channel and number keys through your TV or VCR. The remote control can be programmed by pressing in a three-digit code number that corresponds to a particular manufacturer and brand of Audio/Video component. [. . . ] The three-digit code numbers are listed in the Set-up Code Tables on the backside of this instruction manual. STEP2 Press the [COMPONENT] button (TV, VCR, DVD or AUX) to be programmed and the [OK] button simultaneously for 3 seconds. The selected component LED light will turn on indicating the component is ready to be programmed. [. . . ]