User manual UNIVERSAL REMOTE CONTROL UR3-SR2

[. . . ] The corresponding device LED will turn on indicating that it is ready to be programmed. The next step must be entered while the LED is on. STEP3 Point the remote control toward the equipment and enter the three-digit code number assigned to your brand from the code tables. If there are more than one three-digit number listed for your brand, try one code number at a time until your equipment turns off. [. . . ] Programming a Second TV to the VCR Button STEP1 Press the [VCR] button and the [SELECT] button simultaneously for 3 seconds. The next step must be performed while the LED is on. STEP2 Press the [TV] button. STEP3 Point the remote control toward the TV and enter the three-digit code for your TV from the TV codes table. STEP4 Store the three-digit code by pressing the [VCR] button. The device LED will blink twice to confirm that the code has been stored. STEP4 Press the same [DEVICE] button to store the code. The Device LED will blink twice to confirm that the code has been stored. E. Programming for Advanced Functions. In the CABLE device mode, the A, B, C and blank macro buttons can be programmed to act as macro buttons to send out up to 10 commands with one button press. In this section, when you're instructed to press a [MACRO] button, you need to press either the A, B, C or blank macro button (depending on which button you are attempting to program). *Note : The A, B, and C buttons are not programmable if you have a Digital Cable Box made by Pace, Pioneer, or Scientific-Atlanta. C. To find the Thr ee-Digit Code that W as Pr ogrammed using the Auto Sear ch Method STEP1 Press the appropriate [DEVICE] button and the [SELECT] button simultaneously for three seconds. The next step must be performed while the LED is on. STEP2 Press the [INFO] button. The device LED will blink a number of times indicating the number of each digit for the code. Each digit is separated by a one second interval of the LED being off. Example : One blink, then three blinks, then eight blinks indicates the code number 138. *Note : Ten blinks indicates the number 0. STEP1 Press the [CBL] button to select the CABLE mode. STEP2 Press a [MACRO] button and the [SELECT] button simultaneously for 3 seconds. The next step must be performed while the LED is on. STEP3 Press up to 10 buttons you wish to store. The CBL device LED will blink once for each command entered. 4 5 STEP4 Press the [CH+] button to store the functions that are selected. [. . . ] *Note : If you wish to have the channel keys operate your Cable Box, press the [CBL] button instead of the [TV] button in Step 3. STEP1 Press the [SELECT] button and [CBL] button simultaneously for three seconds. Low Battery Warning When the battery is low (2. 3V-2. 0V) and needs to be replaced with fresh batteries, device LED will blink 2 times in sequence whenever a [DEVICE] button is pressed to turn on equipment. STEP2 Press the [VOL +] button. The device LED will blink. STEP3 Press the [DEVICE] button corresponding to the device that you would like the volume and mute buttons to control. [. . . ]