User manual UNIVERSAL REMOTE CONTROL UR4-P360 TIME WARNER CABLE

[. . . ] STEP4 Store the three-digit code number by pressing the same [DEVICE] button once again. The device LED will blink twice to confirm that the code has been stored. If any of the functions do not work as they should, repeat from Step 2 using the next three-digit code number from the same brand list. [. . . ] STEP1 Remove the battery compartment cover on the back of your remote control. STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below. STEP3 Replace the battery compartment cover. STEP1 Press the [CBL] button to select the CABLE mode. STEP2 Press the [ ] button and [SELECT] button simultaneously for 3 seconds. Program the Volume Controls. By following the steps below, you can program the volume controls (Volume UP, Volume Down and MUTE) to your TV, VCR and Audio. The default volume control settings on the remote control is TV volume control. If you wish you can control the volume via your cable box or audio equipment. Use the following steps to change the volume control settings: STEP1 Press the [CBL] button and the [SELECT] button simultaneously for 3 seconds. To return to original state: If you wish to restore the TV volume control in CABLE mode, repeat the above steps by pressing [ TV ] button in STEP3 Press up to 10 buttons you wish to store. STEP4 Press the [CH+] button to store the functions that are selected. The [CBL] device LED will blink twice to confirm the storage of functions. C. To Find the Three Digit Code Number That was Stored in the Device. STEP1 Press the [DEVICE] button (TV, VCR or AUD) you wish to verify and the [SELECT] button simultaneously for 3 second. The device LED will blink number of times indicating the number of each digit of the code number. Each digit is separated by a 1 second pause of the LED being turned off. Example : One blink, three blinks and eight blinks with an interval of 1 second of LED being turned off, indicates the code number 138. Low Battery Warning. When the battery is low (2. 0V-2. 3V) and needs to be replaced with fresh batteries, device LED will blink 2 times in sequence whenever a [DEVICE] button is pressed to turn on equipment. B. [. . . ] STEP2 Press the [DEVICE] button (TV, VCR or AUD) to be programmed and the [SELECT] button simultaneously for 3 seconds. Programming the System On/Off Button. This button is pre-programmed to turn on all devices with one button press, however you can also program to turn on one or two devices by following these steps: STEP1 Press the [CBL] button. STEP2 Press the [SYSTEM ON/OFF] button and the [SELECT] button simultaneously for 3 seconds. [. . . ]