User manual UNIVERSAL REMOTE CONTROL UR4U-MDVR2B SPECS SHEET

[. . . ] STEP3 Point the remote control toward the Component and enter the 3-digit code number assigned to your brand. *Note : If the 3-digit code number you just entered is correct, the Component will turn Off. If it did not turn Off, continue entering code numbers listed for that brand until the Component turns Off. STEP4 After you've entered the correct code number and the Component has turned Off, press the [POWER] button to turn the Component back On. [. . . ] STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below. Finding a Component Button's Setup Code Number If you used the Auto-Search Method to program a Component, you may not know what the correct code number is. Here is a way for you to identify the code number, so you can record it for future reference. STEP1 Press the [COMPONENT] button (TV, DVD or AUX) you want to verify and the [OK/SEL] button simultaneously for 3 seconds. STEP2 Press the [INFO] button and count the number of times the Component LED light blinks. This number indicates the first digit of the code, followed by the second and third, each separated by a one second pause when the LED will turn off. Example : One blink, (pause), eight blinks, (pause) and three blinks, indicates code number 183. E. Programming the System On/Off Button This allows you to program the System On/Off button so it can send up to four power On/Off commands with one button press. STEP2 Press the [SYSTEM ON/OFF] button and the [OK/SEL] button simultaneously for 3 seconds. STEP3 Press the first [COMPONENT] button you want to store in the [SYSTEM ON/OFF] button and then the [POWER] button. Repeat this for other Components until you have stored all the desired power commands into the [SYSTEM ON/OFF] button. The [CBL] button will blink twice to confirm the commands have been saved. If you wish to operate the CBL volume control in CBL mode, use the following steps. STEP1 Press the [CBL] button and the [OK/SEL] button simultaneously for 3 seconds. To return to original state: If you wish to restore the TV volume control in CBL mode, repeat the above steps but press [TV] in STEP3 . H. AUX Function: Programming a 4 th Component You can take advantage of the AUX function to program a 4th Component such as a second TV, VCR, DVD or Audio Component. STEP1 Turn on the 4th Component you want to program (TV, VCR, DVD or Audio). STEP2 Press the [AUX] button and the [OK/SEL] button simultaneously for 3 seconds. The [AUX] Component LED will light for 30 seconds. Point the remote control toward the Component and enter the 3-digit code number assigned to your brand. *Note : If the 3-digit code number you just entered is the correct number, the Component will turn Off. If it did not turn Off, continue entering code numbers listed for that brand until the Component turns Off I. [. . . ] The Component LED will light for 30 seconds indicating the unit is ready to be programmed. STEP3 Point the remote toward the Component and press the [CH ] or [CH ] button one step at a time or keep it pressed. Release the [CH ] or [CH ] button as soon as the Component turns Off. J. Memory Lock System This remote control is designed to retain programmed memory for 10 years even after batteries are removed from the remote control. Universal Remote Control, Inc. www. universalremote. com OCE-0053B REV 08 (06/01/09) A. [. . . ]