User manual UNIVERSAL REMOTE CONTROL UR5-MDVR

[. . . ] You can verify you have selected the correct code by pressing the [POWER] button, the equipment should turn on or turn off. *Note : If there is more than one three-digit number listed for your brand, try one code number at a time until your equipment turns off. STEP4 Store the three-digit code number by pressing the same [DEVICE] button once again. [. . . ] STEP1 Remove the battery compartment cover on the back of your remote control. STEP2 Check battery polarity carefully, and install the batteries as shown In the illustration below. Programming For Advanced Function. In the CBL mode, the VOD and PPV buttons can be programmed to act as a macro or favorite channel button. STEP2 Press the [VOD or PPV] button and [OK] button simultaneously for 3 seconds. STEP4 Press the [CH+] button to store the functions that were selected. The [CBL] device LED will blink twice to confirm the storage of functions. B. Auto Search Method If the three-digit code numbers assigned to your brand do not turn off your equipment or the code tables do not list your brand, you can use the Auto Search Method to find the correct three-digit code number for your equipment by the following steps: STEP1 Turn on the equipment you wish to operate. STEP2 Press the [DEVICE] button (TV, VCR, DVD or AUX) to be programmed and the [OK] button simultaneously for 3 seconds. Programming a second TV to AUX Mode. STEP1 Press the [AUX] button to be programmed and the [OK] button simultaneously for 3 seconds. The [AUX] device LED will turn on. STEP3 Point the remote control toward the equipment and enter the three-digit code number assigned to your TV brand from the code tables. STEP4 Store the three-digit code number by pressing the [AUX] button once again. The device LED will blink twice to confirm that the code has been stored. If you wish to store the TV channel control in TV mode, use the following steps. STEP1 Press the [TV] button and the [OK] button simultaneously for 3 seconds. To return to original state: If you wish to restore the CABLE channel control in TV mode, repeat the above steps by pressing [CBL] in STEP3 . I. Low Battery Warning. When the batteries are low and need to be replaced with fresh batteries, the remote control LED will blink 2 times in sequence whenever a [POWER] button is pressed to turn on equipment. 4 Operations Default State: Device Default: CABLE Volume Default: You have the option of controlling your TV volume through the Cable box, VCR or DVD. Refer to section G for programming the volume through your Cable box, VCR or DVD. Channel Default: You have the option of controlling your CABLE channel and number keys through the TV or VCR. Refer to section F for programming the channel and number keys through your TV or VCR. 5 Programming the Remote Control A. [. . . ] The default volume control settings on the remote control are as follows: CBL : TV VCR : TV AUX : AUX T V : TV DVD : TV J. Memory Lock System. This remote control is designed to retain programmed memory for 10 years even after batteries are removed from the remote control. E. Programming the System On/Off Button. This is designed to program the System On/Off button so that it can send out up to five power on/off commands with one button press. [. . . ]