User manual UNIVERSAL REMOTE CONTROL UR5U-8800L

[. . . ] STEP3 Point the remote control toward the Component and enter the 3-digit code number assigned to your brand. *Note : If the 3-digit code number you just entered is correct, the Component will turn Off. If it did not turn Off, continue entering code numbers listed for that brand until the Component turns Off. STEP4 After you've entered the correct code number and the Component has turned Off, press the [POWER] button to turn the Component back On. [. . . ] Example : One blink, (pause), eight blinks, ( pause) and three blinks, indicates code number 183. E. Programming the System On/Off Button This allows you to program the System On/Off button so it can send up to five power On/Off commands with one button press. STEP2 Press the [SYSTEM ON/OFF] button and the [OK/SEL] button simultaneously for 3 seconds. STEP3 Press the first [COMPONENT] button you want to store in the [SYSTEM ON/OFF] button and then the [POWER] button. Repeat this for other Components until you have stored all the desired power commands into the [SYSTEM ON/OFF] button. The [CBL] button will blink twice to confirm the commands have been saved. 2 Replacing Batteries Before you program or operate the remote control, you must install two new AA alkaline batteries. STEP1 Remove the battery compartment cover on the back of your remote control. STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below. Programming a `Macro' button. In CABLE mode, the M button can be programmed to act as a `Macro' . This allows you to program from one up to three separate channels that can be accessed by simply pressing the programmed Macro button. STEP2 Press the [M] button and [OK/SEL] button simultaneously for 3 seconds. STEP3 Enter the 3 or 4-digit code for the channel you want programmed first (for example, 007) using the Number Pad, then press the [STOP] button. Then enter the code for the next channel (for example, 050), then press the [STOP] button. STEP4 Press the [CH+] button to store the channels that were selected. Programming Channel Control You can program the channel controls (Channel Up, Channel Down, Last and Numbers) from one Component to operate in another Component mode. Default channel control settings on the remote control are as follows: CBL : CBL DVD : DVD T V : CBL AUX : AUX VCR : CBL D. AUX Function: Programming a 5 th Component You can take advantage of the AUX function to program a 5th Component such as a second TV, VCR, DVD or Audio Component. STEP1 Turn on the 5 Component you want to program (TV, VCR, DVD or Audio). th If you wish to store the TV channel control in TV mode, use the following steps. STEP1 Press the [TV] button and the [OK/SEL] button simultaneously for 3 seconds. To return to original state: If you wish to restore the CABLE channel control in TV mode, repeat the above steps but press [CBL] in STEP3 . B. [. . . ] If any of the functions do not work as they should, you need to find a new code. I. Low Battery Warning When the batteries are low and need to be replaced with fresh batteries, the Component LED lights will blink 2 times in sequence whenever a [POWER] button is pressed to turn on equipment. J. Memory Lock System This remote control is designed to retain programmed memory for 10 years even after batteries are removed from the remote control. G. Programming Volume Control You can program the volume controls (Volume Up, Volume Down and Mute) from one Component to operate in another Component mode. [. . . ]