User manual VEXILAR PRO PACK GETTING STARTED

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual VEXILAR PRO PACK. We hope that this VEXILAR PRO PACK user guide will be useful to you.


VEXILAR PRO PACK GETTING STARTED: Download the complete user guide (33 Ko)

Manual abstract: user guide VEXILAR PRO PACKGETTING STARTED

Detailed instructions for use are in the User's Guide.

[. . . ] GETTING STARTED WITH THE VEXILAR PRO PACK The Vexilar Pro Pack comes pre-assembled with everything you need to start fishing. There are several things that you need to know before you use the system for the first time. [. . . ] The Transducer Support Arm mounts by sliding one of the square ends into one of the vertical slots in the base of the Porta Case. It can be installed four different ways, depending on which side of the unit you want to hang the transducer from. Be sure to remove the float from the transducer cord by pulling it through the slit in the side of the float. Hang the IceDucer from the support arm by setting the stopper in the semicircle at the end of the arm. Make sure that when you are done using your Pro Pack you recharge the battery and disconnect it before long storage periods. Remember to top it off every couple of months when you're not using it. Read the included owners manual for complete instructions on how to operate and interprete the flasher unit. Transducer Support Arm BATTERY CHARGING AND MONITORING Your Vexilar Pro Pack system comes with a high quality sealed lead acid (gel cell) battery. In order to insure maximum running time for your flasher and maximum battery life, you need to follow some simple charging rules. The charger is also protected internally from reverse hook up and short circuits. As long as you follow these instructions, you can expect many hours of use and many years of service from the battery. To Charge the Battery 1. Connect the red charger clip to the positive battery terminal and the black clip to the negative terminal. If you disconnect the charger from the battery and the light gets brighter, the battery is not fully charged. Do not leave the charger connected to the battery for more than 48 hours after the light has come on to full brightness. Tip - For faster charges with automatic shutoff, see your dealer about the optional V-300 Charger. [. . . ] The most accurate reading will be shown when the flasher is turned off and the battery is near room temperature. 200 W 88th St Minneapolis, MN 55420-2752 Phone: 952-884-5291 - Email: service@vexilar. com - Web: www. vexilar. com [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE VEXILAR PRO PACK




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual VEXILAR PRO PACK will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.