User manual VORTICE KRYO POLAR 12

[. . . ] €¢ The appliance must be connected to an efficient earthing system in accordance with applicable electrical safety standards. €¢ If in doubt, ask a qualified electrician to check your system. €¢ Only connect the appliance to the mains if the system can meet the maximum electrical power demanded by the unit. €¢ If the power socket is of a different type to the plug fitted to the appliance, ask a qualified technician to replace the plug with one of the right type. [. . . ] 6 ) 6 36 cm 9 - Fit the rounded connector (13) to the end of the extraction hose. - Make a hole (of more than 152 mm diameter) in the window or wall to accommodate the rounded connector. When the appliance is disconnected from the window or wall, use the blanking cap (14) to cover the hole. 14 ENGLISH Take care not to form kinks in the hose (fig. 10) where hot air could be trapped and then on escaping set off the automatic thermal cut-out system. Fitting the active carbon filters Remove the filter holder frame from the appliance (fig. The length of the hose has been carefully calculated to match the specifications of the appliance. You are advised not to replace the hose or extension as this may lead to a fault developing. Remove the filter fastening device from the frame (fig. 12) 12 Remove the filter from its packaging (fig. 13) 13 15 ENGLISH Insert the filter into the frame (fig. 15) 15 Functions Switching On/Off Press ON/OFF: the appliance comes on in Cooling Mode at minimum speed; the preset temperature is 24°C All the indicator lights come on at the same time; the display shows ambient temperature from 0°C to 50°C to turn the appliance off, press the ON/OFF button. Setting operating mode Press the MODE button to select the required operating mode: Fan, Dry, Cooling, Auto. If the room temperature drops below the set limit, the Cooling Mode automatically cuts out and the appliance continues to operate in Fan Mode at the preset speed. If room temperature rises to above the preset limit, the appliance automatically goes back to Cooling Mode. Refit the filter holder to the appliance Function Control panel (fig. 16) 16 23 22 21 8 20 19 18 7 1 9 2 10 3 11 4 5 Setting the temperature Use the Temperature “UP” and Temperature “DOWN” buttons to set the required temperature. When a temperature has been set, the display will return to showing room temperature. The appliance preset temperature is 24°C Setting fan speed Press SPEED to select the required fan speed setting: Minimum, Medium, Maximum. The indicator light for the mode selected will come on at the same time. 17 16 15 14 13 16 ENGLISH Setting the timer Press TIMER to set the required operating time (from 1 to 24 hours): the Timer light will come on and the display will show how long the appliance is set to run for. After this period, the appliance will switch itself off automatically. [. . . ] 4 When the basin is nearly full, replace the rubber cap and empty the basin. The “condensation tank full” light should now be off. Should you prefer to use the appliance without having to empty the tank every so often, proceed as follows: (fig. On a warm day, turn the appliance on for several hours in Fan mode to thoroughly dry the inside of the unit. [. . . ]