User manual WHIRLPOOL ADG 4000/1 PRODUCT FICHE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL ADG 4000/1. We hope that this WHIRLPOOL ADG 4000/1 user guide will be useful to you.


WHIRLPOOL ADG 4000/1 PRODUCT FICHE: Download the complete user guide (52 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL ADG 4000/1 SCHEDA PRODOTTO (55 ko)
   WHIRLPOOL ADG 4000/1 SCHEDA PROGRAMMI (1637 ko)
   WHIRLPOOL ADG 4000/1 PROGRAM CHART (1632 ko)

Manual abstract: user guide WHIRLPOOL ADG 4000/1PRODUCT FICHE

Detailed instructions for use are in the User's Guide.

[. . . ] Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15°C as well as water hardness and power supply voltage, etc. Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool. com”. Whirlpool is a registered trademark of Whirlpool USA 5019 396 98081 (We reserve the right to make technical modifications) How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Press the ON/OFF button. Large compartment A: How to fill the detergent dispenser With each wash cycle. Small compartment B: For programmes with pre-wash only. A B C Check the rinse aid level Mechanical indicator C. Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. [. . . ] Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. The last programme selected will light up. If necessary (and if provided) the corresponding indicator lamp lights up. Select options “Change programme” Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: Press the ON/OFF button. Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A): 1) Depending on the position, for longhandles utensils, cups and glasses. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Use suitable glasses. • not removable • Insufficient water softening, calcium deposits. • Cannot be washed in the dishwasher. Opaque glasses/ glasses not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. [. . . ] • Cannot be washed in the dishwasher. Opaque glasses/ glasses not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL ADG 4000/1




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL ADG 4000/1 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.