User manual WHIRLPOOL AWO D5706

[. . . ] CONTENTS BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE DOOR CHILD SAFETY (IF AVAILABLE) BEFORE THE FIRST WASH CYCLE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES REMOVING THE FILTER DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE ACCESSORIES TRANSPORT / HANDLING ELECTRICAL CONNECTION BEFORE USING THE WASHING MACHINE 1. Removing the packaging and inspection · After unpacking, make sure that the washing machine is undamaged. · Check that the accessories and supplied parts are all present. · Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. 5. Drain · Connect the drain hose to the siphon or hook it over the edge of a sink by means of the "U" bend supplied. · If the washing machine is connected to an integrated drainage system, ensure the latter is equipped with a vent to avoid simultaneous loading and draining of water (siphoning effect). 6. Electrical connection · Electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions and current standard safety regulations. [. . . ] Place its hooks on the upper end of the back guide rails and slightly push the separator down to fix it (fig. A gap should remain between the separator and the bottom of the main wash chamber, if the separator has been correctly installed (fig. For use with liquid detergent: place the separator in the lower position. Position the separator so that it touches the bottom of the main wash chamber (fig. "D"). 1 C 1 D 23 Notes: · Keep detergents and additives in a safe, dry place out of the reach of children. However, in this case a powder detergent must be used for the main wash. · Do not use liquid detergents when activating the "Start Delay" function (if available on your washing machine). · To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball or bag supplied with the detergent and place it directly inside the drum. · When using descaling agents, bleaches or dyes, make sure that they are suitable for washing machines. Descalers could contain components that can damage parts of your washing machine. Slowly turn the filter counterclockwise until the water begins to drain out. 1 litre of water into the detergent drawer to reactivate the "Eco system". 25 CARE AND MAINTENANCE Appliance exterior and control panel · Can be washed down with a soft, damp cloth. · Dry with a soft cloth. Door seal · Clean with a damp cloth when necessary. · Check the condition of the door seal periodically. Filter · Check and clean the filter regularly, at least two or three times a year (see "Removing the filter"). Do not use flammable fluids for cleaning the appliance. Detergent dispenser 1. Press the release lever in the main wash compartment downward and remove the drawer (fig. Remove the separator from the main wash compartment by pulling it upward (fig. Refit the separator and the grid in the detergent drawer and fit the drawer back inside its housing. A B 26 Water supply hose Check the supply hose regularly for brittleness and cracks and replace it if necessary using a new hose of the same type (available from After-Sales Service or specialist dealer). "C"), periodically check the colour of the transparent coating. If the coating begins to turn red, this is an indication that the hose may have a leak and should be replaced. Contact our After-Sales Service team or specialist dealer to obtain a replacement hose. A Mesh filter for water connection Check and clean regularly. For washing machines with an inlet hose as shown on pictures "A", "B" or "C" (depending on the model): 1. [. . . ] If failure code "FA" appears on the display: Switch the appliance off, pull out the mains plug and turn the water tap off. Tilt the appliance forward carefully to allow the collected water to flow out from the bottom of the appliance. turn the water tap on (if water immediately flows into the appliance again, without the appliance being started, there is a failure. If the failure occurs again, unplug the appliance and contact our After Sales Service (see "After Sales Service"). [. . . ]