User manual WHIRLPOOL C 2010 BL PROGRAM CHART

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL C 2010 BL. We hope that this WHIRLPOOL C 2010 BL user guide will be useful to you.


WHIRLPOOL C 2010 BL PROGRAM CHART: Download the complete user guide (2069 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL C 2010 BL TABLEAU DE PROGRAMMES (2079 ko)

Manual abstract: user guide WHIRLPOOL C 2010 BLPROGRAM CHART

Detailed instructions for use are in the User's Guide.

[. . . ] If you wish another time setting, press OK/Start button again. 3 2 X* 11. 0 0. 80 30 Turn the programme knob to your desired programme position. The OK/Start lamp flashes. 4 Delay Delay X 12. 0 1. 05 150 3 Intensive 70°C Delay X 14. 0 1. 55 155 1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system. 2) Reference programme for energy label in compliance with EN 50242 regulations. [. . . ] • Select a new programme • Press the START button. Switch off the appliance Everything o. k. Only press the OFF button once the START indicator lamp has switched off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. Maintenance and care Maintenance and care Screw on filter cylinder NOTE MARK!Insert Filters Check and clean if necessary Rectifying minor faults yourself . . . 10 Insert and screw on lower and upper arms tightly. Clean spray nozzles under running water (use toothpicks if necessary) . . . Spray arms Remove blockages/ deposits. GB -5- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. . . . is not working/will not start . . . shows “F1” on the display or the START indicator lamp flashes once . . . shows “F4” on the display or the START indicator lamp flashes 4 times . . . shows “F6” on the display or the START indicator lamp flashes 6 times . . . shows “F7” on the display or the START indicator lamp flashes 7 times . . . shows “F8” on the display or the START indicator lamp flashes 8 times Possible causes. . . - If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. Always store detergent in a dry place and do not store it for excessively long periods of time. - For heavily soiled crockery, select a wash programme with a higher temperature (see table of programmes on page 1). - If you select the “Half load/Multizone” option (if available), remember to load only the upper rack or only the lower rack to increase washing power and thus obtain optimum wash results. - In the event of frequent use of the Eco 50°C programme (if available), from time to time select the Frequent use of Eco 50°C. - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 5, Clogged spray arms; filters dirty or not fitted correctly. - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. GB -6- What to do if. . . Crockery and cutlery. . . . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry . . . have discoloured plastic parts . . . opaque glasses, etc . . . removable deposits on glasses . . . glasses not sparkling . . . permanent deposits on glasses Tomato/Carrot juice. Dishes unsuitable for washing in dishwashers (porcelain), Usage of incorrect programmes for glasses. - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water hardness”). - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. - Increase the dosage of rinse aid - see page 3, “Adding rinse aid”. - The rapid programme is intended for quickly washing lightly soiled dishes. If used for a full load of medium/ heavy soiled dishes, the dishes may not dry completely. [. . . ] If you decide to scrap the dishwasher, it must be disposed of in compliance with local waste disposal regulations. danger of suffocation), break the lock of the door so that it can no longer be closed. - This appliance is marked according to the European directive 2002/96/CE on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL C 2010 BL




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL C 2010 BL will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.