User manual WHIRLPOOL MAXY 13 PRODUCT FICHE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL MAXY 13. We hope that this WHIRLPOOL MAXY 13 user guide will be useful to you.


WHIRLPOOL MAXY 13 PRODUCT FICHE: Download the complete user guide (58 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL MAXY 13 MODE D'EMPLOI (423 ko)
   WHIRLPOOL MAXY 13 TABLEAU DE PROGRAMMES (1197 ko)
   WHIRLPOOL MAXY 13 PROGRAM CHART (1193 ko)
   WHIRLPOOL MAXY 13 INSTRUCTION FOR USE (427 ko)

Manual abstract: user guide WHIRLPOOL MAXY 13PRODUCT FICHE

Detailed instructions for use are in the User's Guide.

[. . . ] Before using the washing machine you must remove the transit bolts (see “Installation/Remove the transit bolts”). 3. Install the washing machine • Install the appliance on a solid and level floor surface. In the case of a yielding sub-floor, the appliance should be installed in the corner of a room. • Adjust the feet to ensure that the machine is stable and level on the floor (see “Installation/Adjust the feet”). 4. Water inlet • Connect the water supply inlet hose in accordance with the regulations of your local water company (see “Installation/Connect the water inlet hose”). • Water supply: use hot and cold water 3/4” BSP threaded hose • Tap: connection 100-1000 kPa (1-10 bar). [. . . ] The programme will run again from the point where it was interrupted. Locking controls You can prevent other people turning the machine on by disabling the controls. To do this, simply PRESS and HOLD the “Drain/Spin” button for 3 seconds. To switch off the lock at any time, PRESS the “Drain/Spin” button AGAIN and HOLD for 3 seconds. Child lock screw (inside the door) Activating the child lock 1. Using a coin or the insert from the detergent dispenser, turn the plastic screw underneath the handle anti-clockwise by about 180°. Using a coin or the insert from the detergent dispenser, return the screw to its original position. 20 DETERGENTS AND ADDITIVES Using detergents and additives Pull out the detergent dispenser to its full extent. Pour in detergent: Chamber • Detergent for the pre-wash Chamber • Detergent for the main wash • Stain remover • Water softener (water hardness 4) When using liquid detergent, put the divider insert in the front slot and in the rear slot when using powder detergent. Chamber • Fabric Softener • Liquid starch Only add fabric softeners and conditioners up to the “Max” mark. Chamber • Liquid chlorine bleach Only add the liquid chlorine bleach up to the “Max” mark. Only use this chamber if the “Bleach” column is shown on the enclosed programme chart. Slide the detergent dispenser in until it clicks shut. Liquid detergentuse front slot Divider insert Powder detergentuse rear slot Divider insert 21 Notes: • Keep detergents and additives in a dry place and out of reach of children. Before using the washing machine you must remove the transit bolts (see “Installation”). The appliance will not start; no lamp lights up. Check whether: • the appliance is plugged in; • the wall socket is functioning correctly (use a table lamp or similar to test); • a programme is selected correctly. Final spin results are poor: The appliance has an imbalance detection and correction system. If individual heavy articles are loaded (bathmat, bathrobe, etc. ) this system may reduce the spin speed automatically to protect the appliance or interrupt the spin cycle altogether if the imbalance is too great after several spin starts. • If the laundry is still too wet at the end of the cycle, add other articles of laundry and repeat the spin cycle. • Check whether the spin speed has been reduced to “No spin”. The appliance will not start, but the selected programme lamp is flashing. Check whether: • the appliance door is properly closed (child lock screw); • open the door and close it again. The appliance stops during the programme and the Estimated Remaining Time display is flashing. Check whether: • another programme has been selected. Reselect the desired programme and press the “Start” button, do not add detergent for this programme; • The appliance safety system has been activated. See fault description table. The programme time given on the time remaining display “jumps” suddenly up or down by several minutes, or the programme duration shown at the start increases/decreases by some time: This is a normal adaptation action by the washing machine to factors that can affect the duration of the wash programme, e. g. • excessive foaming; • load imbalance from individual, heavy items of laundry; • longer heating time from correspondingly cold water supply. Because of such influences, the time remaining in the programme is recalculated and updated if necessary. In addition, the washing machine determines the amount of the load during the filling phase and adjusts the initially indicated programme duration appropriately if necessary. Detergent and additives incorrectly washed in. Check whether: • the detergent dispenser inserts are incorrectly located (see “Care and Maintenance”); • enough water is being supplied. Suds Routine When excessive suds are detected, a suds routine automatically starts. This routine removes extra suds and assures proper rinsing of your garments. [. . . ] Make sure: A) The connections are tight, but do not overtighten by using a tool. B) Do not invert their positions (for example: cold fill into hot inlet valve and viceversa). The appliance must not be connected to a mixer tap, or a non-pressurized water heater. Check the supply hoses regularly for brittleness and cracks and replace if necessary using a new hose of the same type (available from After-Sales Service or specialist dealer). [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL MAXY 13




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL MAXY 13 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.