User manual WHIRLPOOL WDF310PAAS DIMENSION GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WDF310PAAS. We hope that this WHIRLPOOL WDF310PAAS user guide will be useful to you.


WHIRLPOOL WDF310PAAS DIMENSION GUIDE: Download the complete user guide (214 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WDF310PAAS (4191 ko)
   WHIRLPOOL WDF310PAAS (4191 ko)
   WHIRLPOOL WDF310PAAS INSTALLATION GUIDE (12235 ko)
   WHIRLPOOL WDF310PAAS (4191 ko)
   WHIRLPOOL WDF310PAAS INSTALLATION GUIDE (12235 ko)

Manual abstract: user guide WHIRLPOOL WDF310PAASDIMENSION GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. WARNING You Need to: ■ Slowly open dishwasher door while someone grasps the rear of the dishwasher. [. . . ] 8 Attach the water supply line (copper tubing or flexible braided line) to the hot water line using a connection configuration that is in compliance with local codes and ordinances. The water supply to the dishwasher should have a manual shutoff valve located under the sink. This will keep it from moving when dishwasher is moved into cabinet opening. (If you are using copper tubing, it will bend and kink easily, so be gentle. ) It should be far enough into the cabinet opening to connect it to the dishwasher inlet on the front left side of the dishwasher. 8 cm) diameter hole in cabinet wall or side of the opening closest to the sink. Route drain hose as shown through hole in cabinet to the front center of opening where drain connection will be made. This will prohibit it from moving when dishwasher is moved into cabinet opening. slowly turn water shutoff valve to “ON” position. Flush water into a shallow pan until clear to get rid of particles that could clog the inlet valve. IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50. Use ¹⁄₄" hex-head socket, nut driver or Torx® T20® screwdriver and previously removed screw to secure cover. If power cord supplied model, remove the first tie strap closest to the plug to maximize the cord length. The following provides instructions to adjust the leveling legs to set the dishwasher to the correct height for your cabinet opening. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you will need to measure the lowest point on the underside of the countertop and the highest point on the floor). refer to “Dishwasher Height Adjustment Chart” to adjust the leveling legs. NOTE: If the minimum cabinet opening height is less than 33⁷ „₈" (86 cm), the rear leveling legs and spacers can be removed for additional clearance. This will allow the dishwasher to fit into a 33¹⁄₂" (85. 1 cm) high cabinet opening, but the dishwasher will be more difficult to move. Rear and front leveling legs are preset at the factory for 34¹⁄₂" [87. € 14 Option 1, Countertop Attachment Built-up floors: If the kitchen floor is higher than the cabinet opening's floor - for example, the kitchen floor tile does not extend into the cabinet opening - add shims as needed in the area shown to bring the dishwasher up to 33¹⁄₂" (85. NOTE: Shims must be securely attached to floor to avoid movement when the dishwasher is in use. [. . . ] Check that dishwasher is still level front-to-back and side-to-side in cabinet opening. Open dishwasher door, remove lower dish rack, and place towel over pump assembly and lower spray arm of dishwasher. This will keep screws from falling into pump area when you are securing dishwasher to countertop. Use ¹⁄₄" nut driver or Torx® T20® screwdriver and previously removed screw to secure cover. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WDF310PAAS




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WDF310PAAS will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.