User manual WHIRLPOOL WGG755S0BE DIMENSION GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WGG755S0BE. We hope that this WHIRLPOOL WGG755S0BE user guide will be useful to you.


WHIRLPOOL WGG755S0BE DIMENSION GUIDE: Download the complete user guide (948 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WGG755S0BE USE & CARE GUIDE (680 ko)
   WHIRLPOOL WGG755S0BE INSTALLATION GUIDE (2849 ko)
   WHIRLPOOL WGG755S0BE WARRANTY INFORMATION (70 ko)

Manual abstract: user guide WHIRLPOOL WGG755S0BEDIMENSION GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. [. . . ] This valve should be located in the same room but external to the range opening, such as an adjacent cabinet. Burner Input Requirements Input ratings shown on the model/serial rating plate are for elevations up to 2, 000 ft (609. Gas supply pressure for testing regulator must be at least 1" water column pressure above the manifold pressure shown on the model/serial rating plate. Line pressure testing above ½ psi gauge (14" WCP) The range and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psi (3. Line pressure testing at ½ psi gauge (14" WCP) or lower The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3. If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs. This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position. NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto the cardboard or hardboard. NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, then tilt forward to adjust the rear legs. When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket. 3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. Please reference the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, to contact service. Check Operation of Cooktop Burners Standard Surface Burners Push in and turn each control knob to the “IGNITE” position. The first time a burner is lit, it may take longer than 4 seconds to light because of air in the gas line. If burners do not light properly: ■ ■ Turn cooktop control knob to the “OFF” position. Check that the range is plugged in and the circuit breaker has not tripped or the household fuse has not blown. Check that the gas shutoff valve is set to the “open” position. If a burner does not light at this point, turn the control knobs to “OFF” and contact your dealer or authorized service company for assistance. The cooktop “Low” burner flame should be a steady blue flame approximately ¼" (0. [. . . ] IMPORTANT: You may have to adjust the “Low” setting for each cooktop burner. See “Adjust Flame Height” in the “Electronic Ignition System” section. Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WGG755S0BE




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WGG755S0BE will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.