User manual WHIRLPOOL WHKM-D40

[. . . ] B Yellow LED: indicates that the fast freeze function is in operation. [. . . ] C Red LED: indicates that the freezer internal temperature is too high. D Green LED: indicates that the appliance is connected to the power supply. E Fast freeze button. 5019 603 01039 D GB F NL E P I GR S N DK FIN Freezer compartment temperature adjustment The appliance is normally factory set for optimum operation at a temperature of -18°C. To adjust the compartment temperature, proceed as follows: · Turn the thermostat knob A to 1/Min for a storage temperature that is less cold. · To deactivate the fast freeze function, press the button (E); if the fast freeze function is not manually deactivated, after approx. · When the appliance is switched on, all the LEDs light up in sequence for a few seconds, after which the appliance begins operation. Alarm signals Signal Temperature alarm The red LED lights up C Cause The internal temperature is above -12°C Solution Press button E until the temperature returns below -12°C again Defrosting 1. To switch on the freezer again, turn knob A. 5019 603 01039 D GB F NL E P I GR S N DK FIN Printed in Italy 03/09 Follow the steps detailed in "Switching on the appliance". [. . . ] · When the appliance is switched on, all the LEDs light up in sequence for a few seconds, after which the appliance begins operation. Alarm signals Signal Temperature alarm The red LED lights up C Cause The internal temperature is above -12°C Solution Press button E until the temperature returns below -12°C again Defrosting 1. [. . . ]