User manual WHIRLPOOL WRS965CIAE ENERGY GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WRS965CIAE. We hope that this WHIRLPOOL WRS965CIAE user guide will be useful to you.


WHIRLPOOL WRS965CIAE ENERGY GUIDE: Download the complete user guide (403 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WRS965CIAE DIMENSION GUIDE (87 ko)
   WHIRLPOOL WRS965CIAE USE & CARE GUIDE (1714 ko)
   WHIRLPOOL WRS965CIAE INSTALLATION GUIDE (408 ko)
   WHIRLPOOL WRS965CIAE WARRANTY INFORMATION (120 ko)

Manual abstract: user guide WHIRLPOOL WRS965CIAEENERGY GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] Once your unit is installed, keep the Use and Care Guide and this Installation Guide in a safe place for future reference. 1175R units are available in Black or White vinyl clad cabinets with matching doors and in Stainless models with a stainless steel door and a black cabinet. All 1175R Black and White unit doors have a slightly contoured handle across the top and are reversible. These doors have recessed front panels that will accept a custom 1/4 inch thick door panel. [. . . ] Do not install hinge on cabinet at this time. ULIN_0104_A Figure 4 2. Remove bottom hinge from cabinet (four screws) and screws on opposite side of cabinet (Figure 7). Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge (Figure 6). ULIN_0105_A Figure 5 4. Remove four plastic plugs (Figure 5) in hinge holes, top of cabinet, opposite side. Install bottom hinge on cabinet, opposite side, aligning flat edge of hinge with outer edge of unit (Figure 8). Partially tighten screws. www. U-LineService. com 6 06/2006 1175R, 1175WC and 1175BEV Models Other Site Requirements Power Supply 1 The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 11. Environmental Requirements Many U-Line models are designed to operate in harsh outdoor/marine environments. Special considerations include the following: (1175 REFRIGERATOR requirements) · The units are designed to operate between 50°F (10°C) and 110°F (40°C). High ambient temperatures (110°F [40°C] or higher) may reduce the unit's ability to reach low temperatures and may also reduce the ice production rate for those models with icemakers. · If the ambient temperature is expected to drop below 45°F (7°C), drain all water from the unit to prevent freezing damage not covered by the warranty. · For best performance, keep the unit out of direct sunlight and away from heat generating equipment. Although this wood trim has been coated with a clear sealer at the factory, it is recommended that the trim be stained (if desired), and receive a final finish coating prior to the unit going into full-time service. WARNING To prevent permanent damage to the inner liner of your unit, the wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the product manufacturer's instructions prior to reinstallation. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty. If staining the trim is desired, it must be done before the application of any type of final finish. Review the following staining/final finish and final finish-only guidelines when staining/ and or sealing the wood to ensure proper adhesion and durability of the finish. Remove all screws securing wood trim to interior components, and remove the trim from the cabinet interior. NOTE: Your model may contain an electronic display panel in the lowest level trim piece. After removing the trim screws, and gently pulling the trim from its location, a wiring harness connector will become visible. Remove all dust from the wood, and apply one coat of Minwax® Polycrylic® Protective Finish using a synthetic bristle brush to the wood. This finish should be applied in a thin coat following the direction of the grain. Apply the finish to the back and sides of the wood first, and allow it to dry for two hours. [. . . ] However, its alignment could have been disturbed during shipment or during door panel installation. Electrical Specifications CAUTION Electrical installation must observe all state and local codes. This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician. The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A power supply (normal household current). An individual, properly grounded branch circuit or circuit breaker is recommended. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WRS965CIAE




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WRS965CIAE will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.