User manual WINDMERE I-210

[. . . ] Never yank cord to disconnect from outlet; instead grasp plug and pull to disconnect. Always disconnect iron from electrical outlet when filling with or emptying of water and when not in use. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. [. . . ] Note: If the power supply cord is damaged, it should be replaced by qualified personnel or in Latin America by an authorized service center. Water-fill opening Dry/steam selector Temperature-ready light Pivoting cord Heel rest This appliance is for household use only. GETTING STARTED remove any labels, stickers or tags attached to the body or soleplate of the iron. Tilt the iron and using a clean measuring cup, pour water into opening until the water reaches the MAX level mark on the water tank (A). Temperature-ready light glows when iron has reached set temperature setting. Tip: if unsure of a garment's fabric, test a small area (on an inside seam or hem) before ironing. Turn the fabric-select dial to the appropriate setting for your fabric (E). See fabric guide on the heel rest and read garment's label to help you determine fabric type. The temperature-ready light glows until it reaches the appropriate temperature. When finished ironing, turn the fabric-select dial to lowest heat setting, move the selector to and unplug the iron. Important: Always stand the iron on its heel rest when powered on but not in use. EMPTYING WATER TANK AFTER IRONING Note: It is not necessary to empty the water after each use. Empty the water by holding the iron over a sink with the tip pointing down. Turn the fabric-select dial to appropriate setting (between 4 and 6) for your fabric (C). See fabric guide on the heel rest and read garment's label to help you determine fabric type. The temperature-ready light glows until it reaches the appropriate temperature. When finished ironing, turn the fabric-select dial to lowest heat C setting, move the selector to and unplug the iron. Important: Always stand the iron on its heel rest when powered on but not in use. [. . . ] Provide you with a reasonably similar replacement product that is either new or factory refurbished. Com/applica, or call our toll-free number, 1-800-231-9786, for general warranty service. â· If you need parts or accessories, please call 1-800-738-0245. [. . . ]