User manual XEROX DOCUPRINT P1202

[. . . ] ENGLISH Xerox DocuPrint P1202 User Guide 1 retph aC Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Printer Unpacking and Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4 Printer Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5 Laser Print Cartridge Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Advanced features include Manual Duplex, Multiple Images, Watermarks, and Booklet Printing. 1 2 3 4 5 6 Turn on the printer, then turn on the computer and start Windows. Type d:\setup16. exe on the command line (where "d" is your CD-ROM drive letter), then click OK. Select Printer Driver and follow the on-screen instructions to complete the installation. 2 3 4 5 1-11 DocuPrint P1202 User Guide Printer Driver Features ENGLISH Setting Number of copies Page orientation Paper size Paper source Graphic quality Graphic mode TrueType fonts EconoMode Overlays Manual duplex Multiple images (N-Up) Watermarks Booklet printing 1 PostScript 2 This Usage/Description Select 1-99 copies. Select from supported paper sizes (see "Printer Specifications"). Create booklets from documents. PCL 6 * * * * * * * * * * * * * PCL 5e * * * * * *2 *2 * 2 PS1 * * * * * * * * *2 setting is not available in the Windows NT 4. 0 version of the PCL 5e driver. 1-12 DocuPrint P1202 User Guide Software Utilities Installation ENGLISH For full details on the printer software, consult the Reference Guide on the DocuPrint P1202 CD-ROM. Installing the USB Port Driver (Windows 98) The USB port driver must be installed in order to print to the DocuPrint P1202 via a USB connection. Installing the RCP and SM (Windows) The RCP (Remote Control Panel) and the SM (Status Monitor) software are Windows-based programs that allow the user to set default printer values as well as monitor the status of the printer. Press and hold button for about four seconds until all lights blink briefly, then let go of button. Press and hold button for about four seconds until all lights blink briefly, then let go of button. If READY light is blinking slowly and printer does not print, press and hold button for about four seconds. Press and hold button for about ten seconds until all lights stay illuminated, then let go of button. After cleaning printer, one cleaning sheet will print. Release unprinted data. Adjust print quality. 1-14 DocuPrint P1202 User Guide Control Panel Indicators ENGLISH On-line Out of paper Receiving data (slow blinking) or Printing (rapid blinking) Paper jam Legend Off Off-line On Blinking Error: · Printer cover open Manual feed mode or · Laser print cartridge not installed Printing with manual feed Insufficient memory for the job Waiting for paper to be manually fed System error 1-15 DocuPrint P1202 User Guide Clearing Paper Jams ENGLISH From Output Area From Input Area (Tray 1 or Tray 2) From Inside Printer 1 Gently pull paper to remove. Printing will resume (if not, see Troubleshooting in on-line Reference Guide). 1 Open paper tray. 1 Open top cover. 2 Gently remove jammed paper. 2 Remove laser print cartridge. From Face-Up Tray 1 Open rear cover. Make sure remaining paper in tray is positioned correctly (refer to "Loading Paper. " 3 Gently remove jammed paper. 3 2 Gently remove jammed paper. Close tray. Printing will resume (if not, see Troubleshooting in on-line Reference Guide). 4 5 Close rear cover. Printing will resume (if not, see Troubleshooting in on-line Reference Guide). Replace laser print cartridge. Close top cover. Printing will resume (if not, see Troubleshooting in on-line Reference Guide). 1-16 DocuPrint P1202 User Guide Installing Memory ENGLISH 1 Turn off power and disconnect the power cable. 4 Install memory SIMM into second slot labeled "DRAM" as shown, slightly angled, notch side up. 7 Replace control board cover. 2 Open control board cover. 5 Push back on the SIMM until it clicks into place. 8 Reconnect power cable and turn on power. 3 Remove metal plate. 6 Reinsert metal plate. Print a configuration sheet (hold down control button until all lights blink, then release). Confirm new memory value on sheet. OPE N OPE N CL OSE CL OSE 1-17 DocuPrint P1202 User Guide Making Installation Diskettes ENGLISH Use the following procedures to copy software installation files from the Xerox DocuPrint P1202 CD-ROM onto floppy diskettes for installation onto computers that do not have a CD-ROM drive or Internet access. To install the software, see "Installing Software from Diskette" (page 1-19). PCL 6 Printer Driver PCL 5e Printer Driver 1 2 Label a new or freshly formatted diskette "DocuPrint P1202 PCL 6 Driver" and insert it into the floppy drive. Windows 95/98 and 3. 1x: Copy d:\XX\pcldrv\pcl6\win9x3x\*. * a:\ (where "d" is the CD-ROM drive letter, XX is the language code1, i. e. Windows NT 4. 0: Copy d:\XX\pcldrv\pcl6\winNT\*. * a:\ (where "d" is the CD-ROM drive letter, XX is the language code1, i. e. EN for English, and "a" is the floppy drive letter). 1 2 Label a new or freshly formatted diskette "DocuPrint P1202 PCL 5e Driver" and insert it into the floppy drive. [. . . ] Class 1 laser product Luokan 1 laserlaite Klass 1 laswer apparat Allonpituus 770-795 nm Teho 0. 40mw +/-0. 04 mw 1-21 DocuPrint P1202 User Guide Printer Certifications (continued) ENGLISH Radio Frequency Emissions United States and Canada Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]