User manual XEROX NUVERA EA NUVERA HINTS AND TIPS SOFTWARE VERSION 9.2

[. . . ] Software Version 9. 2 21 May 2010 701P50710 Xerox Nuvera ® Hints and Tips Guide Xerox Nuvera 100/120/144 EA/MX Production System Xerox Nuvera 200/288 EA/MX Perfecting Production System ©2010 Xerox Corporation. XEROX® and XEROX and Design®, Xerox Nuvera® and FreeFlow® are trademarks of Xerox Corporation in the United States and/or other countries. Technical inaccuracies and typographic errors will be corrected in subsequent editions. [. . . ] DocuSP Remote Workflow 5. 0 software supports DocuSP versions 4. 1, 4. 2 and 5. 0. Version 3. 8 software will no longer be visible to the 5. 0 DRW software. ** Note The print drivers included with the system support Microsoft Windows Vista. Check the driver download page at www. xerox. com for print driver documentation. Hints and Tips Guide 1-1 2 New Capabilities in Version 9. 2 Software The following is a list of new capabilities enabled with version 9. 2 software: 1. 2 Added a generic Icon for DFA devices onto the Machine graph. This will assist in differentiating faults between DFA devices and BFM/DS3500 finishers. When faults occur on a DFA device, the Fault Icon will appear above the DFA Icon instead of above the BFM/DS3500. The new DS3500 is a stacking device that also enables other inline finishing by providing document transport capability and full DFA support to DFA compliant finishing devices. Profiles for new DFA devices introduced after a software release can now be downloaded to connected machines. If a user purchases a new DFA device, the profile is already loaded on the machine enabling immediate use of the new device. Introduced an Alternating Set Mode for machines with dual stackers (Dual BFM). This mode will alternate the destination of the sets of the job between the 2 stackers, eliminating the wait times for the sets to go to the stacker. This mode is most beneficial for small sets to dual BFM by greatly increasing productivity of these types of jobs. The Xerox Tape Binder is now configurable in Dual Mode (2 XTB connected together). . Add a custom edge erase feature that can set the edge erase in the range of 0mm to 6mm for each of the four edges. This allows the user to disable a stacker if they want to restrict jobs from going to that stacker and then re-enable later. Improved jam clearance by adding additional areas that can be purged to the 5B area. [. . . ] If the column is at the end of the table (left side), move it to the beginning (right side). A successfully proofed job will have an icon appear in this column that looks like a green check mark over a document. Hints and Tips Guide 3-3 Release Issues Xerox Nuvera CQ#38117 Short Edge Feed 9x11 Stock Description 9 x 11 stock cannot be loaded short edge first (SEF). Workaround Load an SEF-only stock such as Legal, run one or more sheets on that stock, then unload it and put in 9x11 S CQ#26871 Queue and Job based subsetting fails for odd number of pages duplex jobs Description Subset offset and finishing can be programmed on job in the job manager or on a Queue. It will also work for duplex jobs as long as the request is for an even number of images. [. . . ]