User manual XEROX PHASER 8860

[. . . ] Contents of this publication may not be reproduced in any form without permission of Xerox Corporation. Copyright protection claimed includes all forms of matters of copyrightable materials and information now allowed by statutory or judicial law or hereinafter granted, including without limitation, material generated from the software programs which are displayed on the screen such as styles, templates, icons, screen displays, looks, etc. XEROX®, CentreDirect®, CentreWare®, FinePointTM, Phaser®, PhaserSMART®, PrintingScout®, and Walk-Up® are trademarks of Xerox Corporation in the United States and/or other countries. Adobe Reader®, Adobe Type Manager®, ATMTM, Flash®, Macromedia®, Photoshop®, and PostScript® are trademarks of Adobe Systems Incorporated in the United States and/or other countries. [. . . ] Insert a maximum of 40 envelopes into the tray, flap side down with the flap toward the left side of the tray. Length guide: Press the sides, then slide the guide until the arrow on the guide points to the appropriate paper size imprinted on the bottom of the tray. Width guides: Slide the width guides until the arrows on the guides point to the appropriate paper size labeled on the bottom of the tray. Note: When the paper guides are adjusted correctly, there may be a small space between the envelopes and the guides. Insert the tray into the tray slot, and then push it completely into the printer. Select either Tray 2 Paper Type, Tray 3 Paper Type, or Tray 4 Paper Type, and then press the OK button. In the printer driver, select either Envelope as the paper type or the appropriate tray as the paper source. To order paper, transparencies, or other specialty media, contact your local reseller or go to the Xerox Supplies website for your printer: Do not use any sheet where labels are missing; it may damage the printer. Leave the sheets of labels inside the original packaging until ready to use. return any unused sheets of labels to the original packaging and reseal it. Do not store labels in extremely dry or humid conditions or extremely hot or cold conditions. Storing them in extreme conditions may cause print-quality problems or cause them to jam in the printer. Insert a maximum of 50 sheets of labels into the tray with the side to be printed facedown and the top of the page entering the printer first. On the control panel, press the OK button if the correct paper size and Labels are displayed as the current setup, or select the label size and type: a. In the printer driver, select either Labels as the paper type or Tray 1 as the paper source. Insert a maximum of 400 sheets of labels into the tray with the side to be printed faceup and the top of the page toward the front of the tray. Length guide: Press the sides, then slide the guide until the arrow on the guide points to the appropriate paper size imprinted on the bottom of the tray. Width guides: Slide the width guides until the arrows on the guides point to the appropriate paper size labeled on the bottom of the tray. Note: When the paper guides are adjusted correctly, there may be a small space between the labels and the guides. Insert the tray into the tray slot, and then push it completely into the printer. Select either Tray 2 Paper Type, Tray 3 Paper Type, or Tray 4 Paper Type, and then press the OK button. In the printer driver, select either Labels as the paper type or the appropriate tray as the paper source. [. . . ] The printer should be within 2° horizontal with all four feet in solid contact with the surface. Do not remove the paper source tray that you select in either the printer driver or control panel. The use of unsuitable materials may cause poor performance and a possible safety hazard. Follow all warnings and instructions marked on, or supplied with, the printer, options, and supplies. [. . . ]