User manual XEROX WORKCENTRE 5665

[. . . ] Confirm that the Ethernet cable is plugged into the multifunction machine and into an operational Ethernet port on the network. Note The Ethernet cable is an RJ45 type and is not supplied by Xerox. Configuring an IP Address via DHCP On startup, the multifunction machine defaults to DHCP to obtain its network configurations. A DHCP server delivers an IP address, as well as other configuration settings to the machine. [. . . ] If you use a DHCP server to allocate an IP address to the machine, then proceed as follows: Procedure for Quick Network Setup Using TCP/IP 1. Press the <Start> button on the machine. 1 Quick Network Setup (DHCP) 4. Read the Configuration Report to confirm that an IP address has been allocated and that it is a valid IP address on your network. Note If the IP address starts with 169. xxx. xxx. xxx, then the DHCP server has not properly allocated an address or DHCP is not enabled on your network. From a workstation, open a web browser (such as Internet Explorer), and then enter the machine's IP address. If connected properly, you should see the CentreWare Internet Services web page for your machine. Note CentreWare Internet Services is a powerful tool for configuring the machine remotely. Using the same method as in step d. , enter the Gateway Address. Note If you do not wish to set the gateway address, leave this field blank. Select [Enabled] to filter access to the machine. Note If you do not wish to use the IP filter feature, select [Disabled]. When you have finished establishing TCP/IP, select [Close] on the [Protocol Settings] screen. When IPv6 Mode or Dual Stack is selected in step 7. a. Select [Manually Configured IPv6 Address], and then [Change Settings]. Use the keypad on the screen to enter an IP Address for the machine in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx". [. . . ] Use the keypad on the screen to enter an IP Address for the machine in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx". Select [Manually Configured IPv6 Gateway], and then [Change Settings]. [. . . ]