User manual XEROX WORKCENTRE XE82

[. . . ] WorkCentre XE Series XE60/62/80/82 701P98848 9/98 FCC Compliance in the USA WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] In such cases, go to the Inside the Copier procedure to remove the paper. Straighten the edges of the stack of paper and then reinsert it into the paper tray. Push the paper release lever back again to secure the paper. 23 Inside the WorkCentre E2 Jam 1. Open the front door by pushing in on the front door latches on each side of the front door. 2. To reduce the pressure on the paper, open the front door by pushing in on the front door latches. 2. With the front door partially open, remove any paper that may be in the paper exit area. 24 WorkCentre Fault Codes Fault codes are listed below. If multiple faults exist, only the highest-priority fault code appears in the message display. Fault Code E7 H2 - H4 L1 - L6 U2 C1 CH Toner indicator light Customer Action Switch the main power off, wait 5 seconds and switch the power on. When the toner cartridge replacement indicator appears, the toner cartridge will need to be replaced soon. You may extend the life of the toner cartridge by removing it from the machine and shaking it from side to side to loosen additional toner. Drum indicator light The drum indicator is on when the drum is near end of life (1, 000 pages remaining) and blinks when the drum is at end of life (refer to Drum Cartridge Life). Replace the drum cartridge. Load paper. J2 Jam indicator light P NOTE: All the status codes will be displayed as a fixed 2 character code on the message display. 25 Problem Solving If you have any problems with the operation of your WorkCentre, refer to the table below and on the following pages as well as the WorkCentre Fault Codes. If the problem cannot be solved by carrying out the instructions given below, refer to this User Guide Introduction. Problem Suggested Solution Copier does not come on, Ready indicator does not light. Check that the copier is plugged into an electrical receptacle. Ensure that there is power to the receptacle and that the copier power is switch ON. If the original is light, select the lower copy contrast position to darken the background of the copies. If the original is dark, select the upper copy contrast position to lighten the background of the copies. If defects are on the original, press the copy contrast button to lighten the background of your copies. If the defects are in the same place on every page, clean the document glass and inside the document cover. (Refer to Cleaning the WorkCentre. ) If the defects occur two or three times on each copy, you may have a substance stuck to the drum cartridge. (Refer to Cleaning the Drum Cartridge. ) Ensure that original is positioned correctly on document glass. In high humidity areas do not leave paper in the WorkCentre for extended periods of time. Try removing the toner cartridge from the machine and shaking it from side to side to redistribute the toner. Copies are too light or too dark. Smears, lines, marks, or spots on copies. Copy image is skewed. Image rubs off the copy easily. There are blank lines or sections on the page. 26 Problem Suggested Solution The three trouble indicators are flashing in the copier diagram. The machine is in the program mode. Press the Copy Quality mode button to exit. Auto Jam Drum Toner Frequent copy paper jams. All of the page is blank. [. . . ] THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE. Proof of Purchase Within 10 days of purchase, complete and mail the enclosed registration card to Xerox Corporation, Attn. : TEAM XRX, PO Box 431, East Rochester, NY 144450431. You can also fax your registration card to 1-800-594-5023 or register your warranty via the Internet at the following web site: www. teamxrx. com. When you make a warranty claim, you must present your original receipt or bill of sale to establish your date of purchase. [. . . ]