User manual ZENITH ZEN100 OPERATING GUIDE

[. . . ] UP & DOWN ARROWS Moves highlighted bar within menu to select an option. These buttons will control the VCR when TV or VCR is the active component. A M e n u B Q u i t C REW cc PLAY STOP F. FWD RECORD PAUSE ZEN UNIVERSAL REMOTE ZENITH REMOTE MANUAL 2 ZEN SERIES ZEN REMOTE PROGRAMMING BATTERY INSTALLATION Your Universal Remote requires two AAA alkaline batteries. On the back of the remote, push down on the tab and lift the cover off. [. . . ] Note: If some buttons do not operate your equipment, try one of the other codes or our brand. Press and hold the CODE SEARCH button until the Indicator Light lights, then release the CODE SEARCH button. Press and release the VCR button (the Indicator Light will blink and then remain lit). Find the three digit code for your VCR in the code list and enter it using the Number Buttons. Note: If the LED blinked rapidly when you entered the code, you may have entered an invalid code. If the VCR responds correctly to each of the buttons, no further programming is required. Note: If some buttons do not operate your equipment, try one of the other codes for your brand. For Zenith brand VCRs, press the REC button once, then press it again for three seconds. ZENITH REMOTE MANUAL 3 ZEN SERIES ZEN REMOTE PROGRAMMING PROGRAMMING CABLE BOXES 1. Press and hold the CODE SEARCH button until the Indicator Li ght lights, then release the CODE SE ARCH button. Press and release the CBL button (the Indicator Light will blink and then remain lit). Find the three digit code for your Cable box in the code list and enter it using the Number Buttons. Note: If the LED blinked rapidly when you entered the code, you may have entered an invalid code. If the Cable Box responds correctly to each of the buttons, no further programming is required. Note: If some buttons do not operate your equipment, try one of the other codes or our brand. PROGRAMMING AUX DEVICES Aux buttons allow you program a CD, second TV, satellite system or second VCR. Press and hold the CODE SEARCH button until the Indicator Light lights, then release the CODE SEARCH button. [. . . ] Press and hold the desired mode button until the Indicator Light turns on, then release the mode button. Cycle through the codes by pressing and releasing the CHAN + button (Up Arrow). Keep pressing CHAN + until the device responds (this may take up to 300 tries). [. . . ]