User manual AEG-ELECTROLUX BSE782380M

[. . . ] The appliance is out of circuit only in that case if the plug is removed from the socket. Before cleaning and maintenance always unplug it (do not get it by the cable). If the socket is difficult to reach, switch off the appliance by cutting off the current. Make sure that the power plug is not squashed or damaged by the back of the fridge/freezer. [. . . ] If the ambient temperature is high, the thermostat knob is on the coldest setting (higher numbers) and the appliance is fully loaded, the compressor may run continuously, causing frost or ice to form on the evaporator. If this happens, turn the knob to a warmer setting (lower numbers) to allow automatic defrosting and so a saving in electricity consumption. Keep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. hints for refrigeration Do not store warm food or evaporating liquids in the refrigerator and do cover or wrap up the food, particularly if it has a strong smell. To help you use your refrigerator correctly, here are some useful hints: Raw meat (beef, pork, lamb & poultry): wrap in polythene bags and place on top of the salad compartment, this being the coldest spot in the refrigerator. Meat can only be stored safely in this way for one or two days at the most. : these should be well covered and can be stored on any of the glass shelves. Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom drawer/s. Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to keep out as much air as possible. Milk bottles: these should have a top and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. defrosting Bleeding part of the moisture of cooling chamber in form of frost and ice goes with the operation of the refrigerator. Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases and it needs more energy. At this type of appliance defrosting cooling compartment is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted temperature of the cooling compartment increases and defrosting occurs. After defrosting the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet into the evaporative tray maintained on the top of compressor and evaporates due to warmth of it. Check and clean the outlet of melting water coming during defrosting regularly. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The most typical case of clogging up in the defrost water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of cooling compartment and freezes to it. [. . . ] This operation is made easer since there is, in the internal part of the cover hinge lid a groove that facilates the removal of this coomponent. "Remove the part marked with DX, if the pivot pin is inserted in the right hinge, SX in opposite case. Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. Put together the appliance door and the furniture door and mark the holes as indicated in the figure. [. . . ]