User manual AEG-ELECTROLUX LAV50900

[. . . ] · If the appliance is delivered in the winter months when there are minus temperatures: Store the washing machine at room temperature for 24 hours before using for the first time. Correct use · The washing machine is only designed for the washing of normal domestic laundry at home. · Additions or modifications to the washing machine are not permitted. · Use only detergents and additives that are suitable for use in domestic washing machines. · Dyes/colour removers may only be used in the washing machine, if the manufacturer of these products expressly permits this. [. . . ] 1/4 measuring cup of washing powder. Door and rubber collar Regularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass door. 17 What to do if. . . Remedying minor malfunctions yourself If the programme progress display shows one of the following error messages during operation: ­ E (END) flashes 1x (problem with water inflow), ­ E (END) flashes 2x (problem with water outflow), ­ E (END) flashes 4x (door open), please refer to the following table. After the error has been remedied, press the S/P (START/PAUSE) button. For other error messages (one or more flashing indicators in the programme progress display): Switch the appliance off and then on again. If the error is displayed again, please contact customer service. Problem Possible cause Mains plug not plugged in or fuse not working. Close door ­ there should be an audible click. S/P (START/PAUSE) butPress S/P (START/PAUSE) ton was not pressed for long button for longer. E (END) display flashes 4x, at the same time an Door is not closed properly. E (END) display flashes 1x, at the same time an acoustic signal sounds 1x. Water tap is blocked with limescale or faulty. 18 Problem Possible cause Transit packaging has not been removed. Remedy Remove transit packaging. Washing machine vibrates when operating or is noisy. Adjust feet according to the Screw feet not correctly adInstallation and Connection justed. This does not affect how the machine operates. Screw connection on the inTighten inlet hose. Water is leaking out un- Drain pump cover is not derneath the washing closed properly. Unscrew the pump cover in an anticlockwise direction and remove it. 4. Remove foreign bodies and fluff from the pump housing and from the pump wheel. 5. Check whether the pump wheel right at the back of the pump housing can turn. (It is normal for the pumping wheel to turn jerkily. ) If the pumping wheel cannot be turned, please contact the Customer Care Department. Insert the guides at the sides of the cover into the guide slots and tighten the cover by turning in a clockwise direction. 22 Technical data 5 This appliance conforms with the following EU Directives: ­ 73/23/EEC dated 19. 02. 1973 Low Voltage Directive ­ 89/336/EEC dated 03. 05. 1989 EMC Directive inclusive of Amending Directive 92/31/EEC ­ 93/68/EEC dated 22. 07. 1993 CE Marking Directive Height x Width x Depth Depth when door is open Height adjustment Load (depending on programme) Area of use Drum spin speed Water pressure 850 x 598 x 603 mm 980 mm approx. 5kg Domestic see Rating Plate 1-10bar (=10­100N/cm2=0. 1­1. 0MPa) Consumption values The consumption values were obtained under standardised conditions. They may vary when operating in domestic conditions. Programme knob (Temperature) c (COTTONS/LINEN) 95 ECO (ENERGY SAVING) 2) Load in kg1) 5 5 5 2. 5 2. 5 2 Water in litres 56 45 52 54 56 50 Energy in kWh 1. 90 0. 94 0. 55 0. 50 0. 35 0. 35 Time in minutes 130 125 112 76 64 52 c (COTTONS/LINEN) 40 m (EASY-CARES) 40 d (DELICATES) 30 s (WOOL) H (Hand wash)30 1) The load is determined in accordance with EN 60 456 Standard Loads. 2) Note: Programme setting for tests in accordance with or supporting EN 60 456 and IEC 60 456. Actual consumption will vary from the indicated values depending on water pressure, water hardness, water temperature at filling, room temperature, type and quantity of washing, detergent used, variations in mains voltage and any additional programme functions selected. 23 Installation and connection instructions 1 Safety information for the installation · This washing machine cannot be built-in. · Before using for the first time, check the appliance for damage sustained while it was being transported. [. . . ] Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. [. . . ]