User manual CANDY C2 125

[. . . ] When the appliance location is on carpet floors, attention must be paid so as to ensure that there is no obstruction to the bottom vents. And/or incorrect operation, turn the washing machine off, close the water inlet tap and do not tamper with the appliance. Contact a Candy Technical Assistance Centre for any repairs and ask for original Candy spare parts. (mains cable) be demaged, this is to be replaced by a specific cable available from the after sales service centre. [. . . ] They affect both the selected temperature, keeping it at a constant level throughout the wash cycle, and the mechanical function of the drum. When the detergent enters the garments, the drum rotates in such a way that the detergent is distributed in a uniform manner; during the wash and rinse procedures, however, the speed increases in order to maximise the cleaning action. Thanks to this special system, the efficiency of the wash procedure is improved WITHOUT ANY INCREASE IN THE LENGTH OF THE PROGRAM. EN START DELAY BUTTON Appliance start time can be set with this button, delaying the star by 3, 6 or 9 hours. Proceed as follow to set a delayed start: Select a programme ("STOP" indicator light blinks) Press Start Delay button (each time the button is pressed the start will be delayed by 3, 6 or 9 hours respectively and the corresponding light will blink). Press START to commence the Start Delay operation (the indicator light associated with the selected Start Delay time stops blinking and remains ON). To cancel the Start Delay function : press the Start Delay button until the indicator lights will be off (The STOP light blinks) and the programme can be started manually using the START button or switch off the appliance by turning the programme selector to off position. EN SPIN SPEED BUTTON The spin cycle is very important to remove as much water as possible from the laundry without damaging the fabrics. By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. To reactivate the spin cycle is enough to press the button until you reach the spin speed you would like to set. For not damage the fabrics, it is not possible to increase the speed over that automatically suitable during the selection of the program. It is possible to modify the spin speed in any moment, also without to pause the machine. SPIN SPEED INDICATOR LIGHT When you set a program, the maximum possible spin speed will be automatically shown by the relevant indicator light. Choosing a smaller spin speed by the appropriate button, the relevant indicator light will go on. TIME COUNTDOWN SYSTEM INDICATOR LIGHTS In order to better manage your time, this washing machine features an indicator light system that keeps you constantly informed on the remaining cycle time. Indicator light 90: Remaining time above 60 minutes Indicator light 60: Remaining time less than 60 minutes Indicator light 30: Remaining time less than 30 minutes Indicator light 15: Remaining time less than 15 minutes Indicator light Stop: End of the programme. EN BUTTONS INDICATOR LIGHT The indicator light around the option buttons will light when specific options are selected The programme carries out with the programme selector stationary on the selected programme till cycle ends. Cotton, linen Cotton, mixed resistant Cotton, mixed Whites Whites with Prewash Fast coloureds Fast coloureds Non fast coloureds Cotton Mixed fabrics and synthetics Mixed, resistant Cotton, mixed fabrics, synthetics Synthetics (nylon, perlon), mixed cotton Non fast coloureds cold wash Fast coloureds with Prewash Fast coloureds Fast coloureds Non fast coloureds Mixed, delicate synthetics Non fast coloureds Non fast coloureds cold wash Delicates Please read these notes * Maximum load capacity of dry clothes, according to the model used (see rating plate). When washing heavily soiled laundry it is recommended the load is reduced to 3 kg maximum. The spin speed may also be reduced, to match any guidelines suggested on the fabric label, or for very delicate fabrics cancel the spin completely this option is available with a spin speed button. When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine. Pour the bleach into the liquid bleach container, inserted into the compartment marked "II" in the detergent drawer, and set the special programme "RINSE" . [. . . ] - The non-ionic surface-active agents present in the composition of washing machine detersives are often difficult to remove from the washing itself and, even in small quantities, may produce visible signs of the formation of foam. 2 If your washing machine fails to function, carry out the above-mentioned checks before calling the Candy Technical Assistance Service. The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics. [. . . ]