User manual CANDY CHD90

[. . . ] 3), a vacuum suction unit must be connected; this exhaust will operate separately, conveying the exhaust air through the unit. To facilitate installation, before starting remove the grease filter/s: press inward on the clamp at the handle and pull the filter downward (Fig. Secure the 2 supports (C) to the hood, one on the left and one on the right; insert the utensil holder into these supports. [. . . ] The other end of the wire is secured to the terminal block on the outside control unit. Insert the extension pipes setting them on the hood; extend the upper flue to the ceiling and secure with the 2 screws (G) - Fig. Filtering hood: Secure the deflector to the upper flue using the 4 special screws (provided) ­ Fig. Take the 2 assembled extension flues and set them on the hood; extend the upper flue to the ceiling and secure with the 2 screws (G) - Fig. Extend the lower flue taping it in place and then connect the flexible pipe to the hood reduction. Install the charcoal filters by pressing the 2 tabs on the filter down into the special housing (Fig. Depending on the model, the unit is equipped with the following controls: Controls shown in Fig. Button B = turns the TIMER on/off: press once to turn the timer on, therefore, after 5 minutes, the motor cuts out (at the same time the selected speed blinks on the display); the timer remains on if the motor speed is changed. Indicates Timer On when the number blinks; - indicates Filter Alarm when the central segments is on or blinking. Button D= makes the motor work (at the last speed selected); pushing the button again, the speeds of the motor are sequentially selected from 1 to 4; keeping this button pressed for about 2 seconds shuts down the motor. When the central segment on the display goes on), the grease filters must be cleaned (30 hours of operation); when the central segment starts blinking, the grease filters must be cleaned and the charcoal filters replaced (120 hours of operation). Obviously, if the hood is not a filtering model and does not have a charcoal filter, clean the grease filters both when the central segment goes on and when it starts blinking. The filter alarm can be seen when the motor is off and for about 30 seconds. To reset the hour counter, keep the button pressed for 2 seconds while the alarm can be seen. [. . . ] If the model purchased has the controls shown in Figure 18/19/20, the charcoal filters must be replaced according to use: on the average once every 6 months. If the model purchased has the controls shown in Figure 20, the charcoal filters must be replaced each time the light button (Fig. 23: to replace the incandescent light bulbs, remove the grease filters so as to be able to access the inside of the unit; remove the screw securing the light fitting and then, working from inside the hood, push the light fitting pin towards the inside of the unit. [. . . ]