User manual CANDY DUO609X
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CANDY DUO609X. We hope that this CANDY DUO609X user guide will be useful to you.
Manual abstract: user guide CANDY DUO609X
Detailed instructions for use are in the User's Guide.
[. . . ] RECOMMENDATIONS
READ THE INSTRUCTIONS CAREFULLY TO MAKE THE MOST OF YOUR APPLIANCE. We recommend you keep the instructions for installation and use for later reference, and before installing the appliance, note its serial number below in case you need to get help from the after sales service. Identification plate is located at the back of the Duo.
THE COMPANY SHALL NOT BE LIABLE IF THE INSTRUCTIONS PROVIDED IN THIS DOCUMENT ARE NOT COMPLIED WITH.
SAFETY INSTRUCTIONS
You should entrust the electrical connection of your appliance to an approved installer or technician with similar qualifications. For safety reasons under no circumstances should any modifications be carried out to this appliance. [. . . ] - Set the required programme by pressing Programme selection button, LED of the chosen programme will turn on (2 LEDs for COLD RINSE programme). - Close the door (after audible signal), the chosen programme will start automatically.
USE THE DISHWASHER
Opening the door Grip the handle in the front panel and pull forward. If the machine comes open while it is working, an electrical safety device automatically switches everything off. For the machine to work properly, the door should not be opened while it is in operation. Make sure that the spray arm is free to rotate and is not obstructed by cutlery, crockery or pans. Interrupting a programme lt is not recommended that the door be opened while a programme is running, and especially not during the main wash phase and final drying. If you wish to change or cancel a programme that is running, carry out the following procedure: . open the door, keeping the Programme selection button "P" pressed in until all 4 indicator lights are flashing. Before starting a new programme, you should check that there is still detergent in the dispenser. WARNING: if the door is opened during the drying phase, an intermittent audible signal is activated to advise that the cycle is not yet completed. End of programme The end of the programme is indicated by an audible signal. When the door is opened the programme selection indicator lights start flashing. Deactivating the audible signal The audible function can be deactivated in the following way: - press the On / Off button, - wait till the programme LEDs blink, - within 2 minutes, press and keep pressed for at least 30 seconds the Programme Selection button (the programme LEDs will still blink and an intermittent audible signal is heard). - Once the first two LEDs on the left are illuminated without blinking and the audible signal is off, release the button (the audible signal function is active). - Press again the Programme Selection button, the first two LEDs on the left will go off and the other two LEDs will turn on (the audible signal function is deactivated). - An audible signal will confirm that the setting is completed - To set again the audible signal function repeat the whole procedure. Attention - The dishwasher is equipped with an anti-overflow safety device which in the event of anomaly intervenes by evacuating water in excess. Fault Signals If malfunctions or faults occur when a program is running, the LED that corresponds to the selected cycle (2 LEDS for COLD RINSE programme) will blink rapidly and an audible signal will be activated. In this case, turn the dishwasher off by pressing the On / Off button. After checking to make sure the water inlet hose tap is open, that the drain hose is not bent and that the siphon or filters are not clogged, re-start the selected program. To ensure the correct operation of the anti-overflow safety device, it is recommended not to move or to tilt the dishwasher during operation. If it is necessary to move or to tilt the dishwaher, first make sure the washing cycle is finished and that no water is left in the tank.
PRELIMINARY OPERATIONS AND CLEANING THE FILTER UNIT
The filtering system is composed of : - a central filter cup which traps the largest food particles. [. . . ] We advise again using the dishwasher to wash items in thermoplastic, cutlery with wooden or plastic handles, saucepans with wooden handles, items in aluminium, crystal, leaded glass unless otherwise stated. It is therefore a good idea before loading the whole batch to wash just one of the items first so as to be sure that others like it will not fade. It is also a good idea not to put silver cultery with non-stainless steel handles into the dishwasher as there could be a chemical reaction between them. NB : when buying new crockery or cutlery always make sure that they are suitable for washing in a dishwasher. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CANDY DUO609X
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CANDY DUO609X will begin.