User manual CANDY FCT886X WIFI

[. . . ] During cooking, moisture may condense inside · Only use the meat probe recommended for this The oven cavity or on the glass of the door. To reduce this effect, wait 10- · Do not use a steam cleaner for cleaning 15 minutes after turning on the power before operations. Ln any case, the Cook the vegetables in a container with a lid · Avoid leaving food inside the oven after cooking BUT MUST BE DIRECTLY CONNECTED TO THE For more than 15/20 minutes. The connection to the power WARNING: the appliance and accessible parts source must be carried out by a suitably qualified Become hot during use. [. . . ] sAVING AND RESPECTING THE ENVIRONMENT Where possible, avoid pre-heating the oven and always try to fill it. Open the oven door as infrequently as possible, because heat from the cavity disperses every time it is opened. For a significant energy saving, switch off the oven between 5 and 10 minutes before the planned end of the cooking time, and use the residual heat that the oven continues to generate. Keep the seals clean and in order, to avoid any heat dispersal outside of the cavity. If you have an electric contract with an hourly tariff, the "delayed cooking" programme makes energy saving more simple, moving the cooking process to start at the reduced tariff time slot. By placing the mark on the appliance, we are confirming compliance to all relevant European safety, health and environmental requirements which are applicable in legislation for this product. Hereby, Candy Hoover Group Srl declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www. Collects the residues that drip during the cooking of foods on the grills. Wash all accessories and wipe inside the oven with a solution of hot water and washing up liquid. Set the empty oven to the maximum temperature and leave on for about 1 hour, this will remove any lingering smells of newness. Use of the Oven (According to model) WARNING : the first operation to carry out after the oven has been installed or following the interruption of power supply (this is recognizable the display pulsating and showing 12:00 ) is setting the correct time. 00 by turning the left function selector to the position Minute Minder, and using the button " - ". Turn back the left function Press the button " + " during 5 button " + " during 5 seconds. Child lock is available when " STOP It disables the use of the oven. Power consumption of the product in networked standby if all wired network ports are connected and all wireless network ports are activated: 2, 0 W If the WiFi led blinks it means that the WiFi module is On. If the oven is enrolled: turn the knob to WiFi reset position and then to Off position within 30 sec. Turn the functions knob to the WI-FI RESET program and wait 30 seconds. When the WiFi LED starts blinking, you can proceed with pairing within 5 minutes. Hereby, Candy Hoover Group Srl declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www. The fan circulates air at room temperature around the frozen food so that it defrosts in a few minutes without the protein content of the food being changed or altered. [. . . ] Remove large or coarse food residues from the inside of the oven using a damp sponge. 1- Rotate the function selector to the position " The preset time is 90 min, this can Be varied from 90 min (Eco mode) to 120 min (Sup mode) via the If the oven is very dirty, it is Recommend o increase the time to 120 min, if the oven is moderately dirty Reduce the cleaning cycle time to 90 min. 2- It is possible to defer the start time of the pyroclean cycle by changing the END time via the programmer. 3- After few minutes, when the oven reaches a high temperature, the door The pyroclean cycle can be stopped at any time by Turning the function selector back to '0' (the word OFF will be displayed for 4- Once the pyroclean cycle is finished, the pyrolysis will switch off On the display appears the indication "END" until the door is 5- You can turn the function selector back to " 0 " but if the temperaure is Still high, the "0--n " indication appears to inform that the door is locked. [. . . ]