User manual DANBY DPAC10061
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DANBY DPAC10061. We hope that this DANBY DPAC10061 user guide will be useful to you.
Manual abstract: user guide DANBY DPAC10061
Detailed instructions for use are in the User's Guide.
[. . . ] 13 x TECHNICAL SPECIFICATIONS
E-3
ENGLISH
View of the Unit
The figures are shown in this instruction may differ from yours depending on the model.
Indoor Unit
Air flow blades(outlet)
Air inlet
Air filter(under the grille)
Timer indicator Remote control sensor Filter Sign indicator
On/Off button On/Off indicator Fan indicator Removing frost indicator (Except Cooling Only Models)
E-4
Outdoor Unit
TYPE A
Air outlet Connection valve
Outdoor Unit
TYPE B
Air outlet
Connection valve
Outdoor Unit
TYPE C
Air outlet
Connection valve
Outdoor Unit
TYPE D
Air outlet
Connection valve
Outdoor Unit
TYPE E
Air outlet
Connection valve
Note
If the heat exchanger in the outdoor unit gets dusty, cooling efficiency may fall. However, be careful when you wash the surface of the heat exchanger because it is very sharp.
E-5
ENGLISH
Wireless Remote Controller-Buttons and Display
The wireless remote controller is an optional accessory. To use the wireless remote controller, refer to an appropriate manual.
Operating mode Temperature setting
Mode selection button
Temperature adjustment buttons Filter Reset button
Fan speed Air flow direction On Timer setting Off Timer setting Battery discharge indicator
Fan speed adjustment button Swing button On Timer button Off Timer button
On/Off & Timer Set/Cancel button
Note
- After cleaning the air filter, press the filter reset button. [. . . ] To use the wired remote controller, refer to an appropriate manual.
Operating mode Removing frost indicator (Except Cooling Only Models) Centralized controller indicator
(In case of installing the Centralized controller)
Communication error indicator On Timer setting Off Timer setting Test indicator Temperature adjustment buttons On Timer button Off Timer button Test button
Mode selection button
Note
- Test button is for your installation specialist. Then the wired remote controller will display the FILTER SIGN indicator when the time to clean the air filter; refer to page 11. - The heating mode( ) is not selected in cooling only models.
Centralized Controller
The centralized controller is an optional accessory and it is installed on the wall. To use the centralized controller, refer to an appropriate manual.
Operating lamp
All On button
All Off button
On/Off indicators On/Off buttons Index
Note
Operating lamp comes on when at least one air conditioner connected to the centralized controller is operating.
E-8
Operating Recommendations
ENGLISH
E-9
Here are a few recommendations that you should follow when operating your air conditioner. Topic Heating performances Recommendation The heat pump function of the air conditioner absorbs heat from outside air and brings it indoors. As the temperature of the outside air drops, the heating performance of air conditioner will decrease. If you find that the room is not warm enough, using an additional heating appliance is recommended. When outside temperature is low but humidity is high, frost may form on the outdoor unit at HEAT mode. x The defrost mode will be triggered automatically for about ten minutes. Note When you have installed the Bio-Pure filter, do not allow any liquids to contact the filter. Note You can use all 4 points of the indoor unit for installing the front grille and the safety clips depending on your requirement. After cleaning the air conditioner, press the Filter Reset button.
Note
Wired Remote Controller
Wireless Remote Controller
E-11
Bio-Pure Filter Installation (Optional)
The air conditioner can be fitted with a Bio-Pure filter to remove minute dust particles. The service life of the filter is approximately three months depending on the time during which the air conditioner is used.
1
Remove the vinyl packing from the filter. Note Do not remove the packing from a bio-pure filter until you wish to use the filter, as it will lose its properties.
2
Open the front grille by pulling the tabs on the grille.
3
Remove the front grille. 3-2 Open the front grille about 45° and pull it forward.
4
Pull out the air filter.
5
Locate the bio-pure filter on the center of air filter.
6
Secure the bio-pure filter with four screws.
7
Reinstall the air filter, the front grille and the safety clips.
E-12
Solving Common Problems
ENGLISH
Before contacting the after-sales service, perform the following simple checks. Problem Explanation/Solution
The air conditioner does not x Check that the breaker used for the air conditioner is switched on. operate at all
Wired Remote Controller
The air conditioner does not x is displayed on the wired remote controller. In this case, operate with the remote turn the air conditioner off and contact your dealer. [. . . ] controller
Wired Remote Controller
When turning on/off the air conditioner, it is not turned on/off immediately. x In case of using the wired remote controller for a group, the air conditioners connected to the remote controller are turned on/off in order. Thus, it takes some time(up to 32 seconds).
Wireless Remote Controller
The air conditioner does not x Check that there are no obstacles between you and the remote operate with the remote control sensor. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DANBY DPAC10061
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DANBY DPAC10061 will begin.