User manual FLYMO EASI-TRIM EHT450S

[. . . ] The operator is responsible for following the warning and safety instructions in this manual and on the product. Never use the mower unless the grassbox or guards provided by the manufacturer are in the correct position. Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged. Keep the cable away from the blade. Warning Read the user instructions carefully to make sure you understand all the controls and what they do. Beware of severing toes or hands. [. . . ] Never operate the product with damaged guards or without guards in place. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Do not tilt product when the motor is running, except when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Always ensure that both hands are in the operating position before returning the appliance to the ground. Never pick up or carry a product when it is operating or still connected to the mains supply. Remove the plug from the mains : before leaving the product unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition. ; if the product starts to vibrate abnormally. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. Only use the replacement blade, and blade bolt specified for this product. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. The quality of your lawn will suffer and collection will be poor if you cut too low. HEIGHT OF CUT Low Low to Medium Medium Medium to High High WHEELS POSITION Front position 2cm Rear position 2cm Front position 2cm Rear position 4cm Front position 4cm Rear position 4cm Front position 4cm Rear position 6cm Front position 6cm Rear position 6cm Starting and Stopping M N To Start your Lawnmower 1. To secure, position loop over the hook and pull the cable back through the slot (N). Tilt the handle downwards to slightly raise the front of the lawnmower and to reduce the risk of lawn damage whilst starting. The switchbox is provided with a lock-off button (P1) to prevent accidental starting. Press and hold the lock-off button (P) on the switchbox, then squeeze one of the Start/Stop levers towards the upper handle (Q). Continue to squeeze the start/stop lever towards the upper handle and release the lock-off button (R). Lower the lawnmower to its proper operating position and commence mowing. · IMPORTANT - Do not use the start/stop levers intermittently To Stop your Lawnmower 1. Release the pressure on the Start/Stop lever. P Q 1 R How to Mow 1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. [. . . ] Your product is uniquely identified by a silver and black product rating label 5. If you have a problem with your machine contact your local Approved Service Centre ensuring you have full details of your product as described on the product rating label. Should it be necessary for work to be carried out by your Service Centre, it is important to take your complete machine including cable and any extension cables used. A network of specialist dealers can be found in your local Yellow Pages. [. . . ]