User manual HUSQVARNA RZ3016 CA
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual HUSQVARNA RZ3016 CA. We hope that this HUSQVARNA RZ3016 CA user guide will be useful to you.
Manual abstract: user guide HUSQVARNA RZ3016 CA
Detailed instructions for use are in the User's Guide.
[. . . ] Operator Manual
RZ3016 CA / 966503701
Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.
In order to implement improvements, specifications and designs can be altered without prior notification. Note that no legal demands can be placed based on the information contained in these instructions. Do not modify or install non-standard equipment to the unit without consent from the manufacturer. Modifications to the unit may cause unsafe operations or damage the unit.
When this product is worn out and no longer used, it should be returned to the reseller or other party for recycling.
©2010 HTC All rights reserved. [. . . ] Pull the lever backward to activate the brake and push forward to release it. IMPORTANT INFORMATION The machine must stand absolutely still when applying the parking brake. Release the parking brake before moving the mower.
8050-005
Parking brake not activated
Throttle Control
The throttle control regulates the engine speed and thereby the rate of rotation of the blades. In order to increase or decrease the engine speed, the control is moved forward or back respectively. Avoid idling the engine for long periods, as there is a risk of fouling the spark plugs. USE FULL THROTTLE WHEN MOWING, for best mower performance and battery charging.
8050-006
Throttle control
Ignition Switch
The ignition key is placed on the control panel and is used to start and stop the engine.
IMPORTANT INFORMATION Do not run the starter for more than five seconds each time. If the engine does not start, wait about 10 seconds before retrying.
8050-006
Ignition switch
19
CONTROLS
Choke Control
The choke control is used for cold starts in order to provide the engine with a richer fuel mixture. For cold starts the throttle should be pushed forward to the choke position.
WARNING!Observe caution and fill the tank outdoors (see the safety instruction).
8050-006
Choke control
Refueling
Read the safety instructions before refueling. Make sure the fuel cap is properly tightened and the cap gasket is not damaged. The engine will run on a minimum of 85-octane unleaded gasoline (no oil mix). Damage to engine and components may occur.
IMPORTANT INFORMATION Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur.
Fuel tank
8050-012
WARNING!Allow engine and exhaust system to cool at least two (2) minutes or a safe temperature before refueling.
WARNING!Do not store, spill or use gasoline near an open flame.
20
CONTROLS
Fuel Shut Off Valve
The fuel shut off valve is located in the fuel line under the seat. Rotate the valve ¼ turn clockwise to turn fuel OFF.
IMPORTANT INFORMATION In order to obtain an even cutting height, it is important that the air pressure is 15 psi in all tires.
8050-010
Fuel shut off valve in the OPEN position.
Mower Deck Lifting Lever
The lifting lever is used to place the mower deck in the transport position or one of the 6 different cutting height positions. The cutting height is set by placing a lever in the notch for the desired cutting height. The lifting lever can also be used to temporarily adjust the cutting height, such as when passing a minor bump in the lawn.
IMPORTANT INFORMATION Always use the high position (F) to transport.
8058-085
The mower deck’s lifting lever
Tracking
If the mower is not tracking straight, check the air pressure in both rear tires. (1 bar) Tracking must be checked on a flat and level concrete or blacktop surface. If the unit still does not track straight contact your Husqvarna workshop for adjustments.
21
CONTROLS
Blade Control Lever
To engage the mower blades, slowly lift the lever up and into the the lock notch.
WARNING! [. . . ] Clean, charge, and store the battery in a cool place, but protect it from direct cold. 8. Store the machine in a clean, dry place and cover it for extra protection.
WARNING!Never store an engine with fuel in the tank indoors or in poorly ventilated spaces where fuel vapor can come in contact with open flames, sparks, or a pilot light such as in a boiler, hot water tank, clothes drier, etc. It is very flammable and can cause serious personal injury and property damage. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HUSQVARNA RZ3016 CA
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual HUSQVARNA RZ3016 CA will begin.