User manual JONSERED LM 2148 CMD

[. . . ] Do not use the lawnmower if the charging cable is not in good condition. Do not attempt to charge other products with the charger from this unit. Charging should only be carried out in a safe location where neither battery nor cord cable can be trodden on or tripped over. Ensure that neither the charger nor the battery are exposed to moisture. [. . . ] Please Note :- Ensure no gap remains between the safety flap and the grassbox Where grass collection is not required you can use the lawnmower without the grassbox. Ensure the safety flap is fully closed Check oil level periodically and after every five hours of operation. Add oil as necessary to keep the level to the FULL mark on the dipstick. Change the oil after the first five hours operation and thereafter every 25 working hours. Always change the oil while the engine is warm but not hot - never attempt any maintenance on a hot engine. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with a filter. Please Note :- move the product away from the fuelling area before starting Please Note:- When starting the engine for the first time, fill with oil and petrol as described above in the Oil and Petrol section. Advance engine speed control to FAST `+' as described in the Use - starting and stopping section. If engine fails to start after three pulls of the pull cord, push primer bulb three times and repeat step 3. Move engine speed control to FAST `+' position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. Move the Engine Speed Control to the FAST `+' position before starting. Pull the operator presence control (OPC) to release the brake on the engine and the blade. Pull the recoil starter fully towards you until you feel the full resistance, return the handle slowly then pull the handle firmly towards you to its full extent. After the engine has started, allow to run for 30 seconds before commencing to use. Forward drive is engaged and disengaged with the Powerdrive lever at the top of the handle (G4). If the engine fails to start when you turn the key your battery may need charging. Engaging the Drive - See LM2148CMD Stopping - See LM2148CMD Please note:- Your LM2148CMDE can be started manually by following steps 1-5 in Starting & Stopping LM2148CMD Key Start Only - During mowing, your engine will recharge the battery. Start mowing from the outside edge of the lawn, mowing in strips in alternate directions (K2). Mow twice a week in the growing season, your lawn will suffer if more that one third of its length is cut at one time and this may also result in poor collection. Please Note:Do not overload your Lawnmower When mowing in long thick grass a first cut with the cutting height adjusted to its highest setting, see Cutting Height, will help reduce engine overload and will help prevent damage to your lawnmower. [. . . ] Batteriet skall lämnas in till en godkänd servicedepå eller till Din lokala återvinningsstation. Om batteriet efter en längre period av användning snabbt tappar laddning efter en full laddning på 24 timmar är det troligen tid att byta till ett nytt batteri. Safety flap is fully closed Nota bene: Controllare che non vi siano fessure tra il deflettore di sicurezza e il cesto raccoglierba. DL5 6UP Certify that a sample of the above product has been tested using directive 81/1051/EEC as a guide. [. . . ]