User manual JONSERED RT 150

[. . . ] Use extreme caution when reversing or pulling the machine towards you. Start the engine carefully according to instructions and with feet well away from the tool(s). Stop the engine: - whenever you leave the machine and before refuelling. [. . . ] Pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point). Place choke lever on engine halfway between "CHOKE" and "RUN" position (fig. 9) halfway between "FAST" and "STOP" position for a few minutes to warm up. Keep drive control bar in "disengaged" position when starting the engine (fig. In order to idle smoothly, a new engine may require 3 to 5 minutes runnig time above slow idle speed. Idle speed has been adjusted to be correct after this break-in period. Always release drive control bar before moving shift lever into another position. Don't back yourself into a solid obstruction such as a tree, fence, etc. 10) Swing the handle in the opposite direction you wish to turn, being careful to keep feet and legs away from the tines. 10) are slotted so that they can be raised for deep tilling and lowered for shallow tilling to protect small plants from being buried. Lower the depth stake to its lowest position and insert the depth stake pin in the topmost hole. Always release drive control bar before moving shift lever into another position. Tilling is digging into, turning over and breaking up packed soil before planting. Tines will not readily penetrate dry, hard soil which may contribute to excessive bounce and difficult handling of your tiller. [. . . ] Belt guard Screw Screw Hairpin clip and retaining pin Hex nut (located behind tire) 18) from hub of left hand wheel. Remove belt guard by removing two (2) screws, one (1) hex nut and one (1) washer so that belt guard can slide straight out away from engine (fig. Place new belt in groove to transmission pulley (large pulley) and into groove of engine pulley (fig. [. . . ]