User manual KENWOOD CHEF XL KPL9000S

[. . . ] L Do not move or raise the mixer head with an attachment fitted as the Kitchen Machine could become unstable. L Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. L The maximum rating is based on the attachment that draws the greatest load. L Important ­ The finger guard on the machine is fitted during Manufacture and no attempt should be made to remove it. [. . . ] Note: If the K-beater or Whisk are not picking up ingredients from the bottom of the bowl refer to the "Tool Adjustment" section. 4 Lift the mixer head slightly then turn the head-lift lever anti-clockwise and lower the mixer head until it locks. 7 Release the tool by turning clockwise to unlock from the tool socket and then remove. Before whisking egg whites, make sure there is no grease or egg yolk on the whisk or bowl. Points for bread making Important · Never exceed the maximum capacities Stated - you may overload the machine. If you hear the machine labouring, switch Off, remove half the dough and do each half separately. Then add the yeast and the sugar and leave to stand for about 10 minutes until frothy. Put the dough into a greased polythene bag or a bowl covered with a tea towel. Important Ensure that no bowl tools are fitted or stored in the bowl when using other outlets. Flour weight Flour weight (enriched with butter and eggs) Total weight Fruit cake mix (Creaming fat and sugar method) Then increase to speed `1' The tools are set to the correct height for the bowl supplied in the factory and should not require adjustment. 2 Raise the mixer head and insert the Needs to be adjusted, raise the mixer head and remove the tool. Ideally the whisk and K-beater should be almost Touching the bottom of the bowl 6. 4 Using the spanner provided loosen the nut sufficiently to allow adjustment of the shaft 7. To lower the tool closer to the Bottom of the bowl, turn the shaft anticlockwise. To raise the tool away from the bottom of the bowl turn the shaft clockwise. 7 Repeat the above steps as necessary until the tool is set correctly. A little grease may appear at the slow Speed outlet 2 when you first use it. tools · Wash by hand, then dry thoroughly or Wash in the dishwasher. [. . . ] Adjust the height using a suitable spanner ­ see "Tool Adjustment" section. Attachment must have the KAX twist connection system to fit the outlet. If you own attachments featuring the Bar Connection System you will need to use the KAT002ME adaptor to connect these to the Twist Connection System on your Kitchen Machine. If the machine will not operate, remove some of the ingredients to reduce the load and restart. [. . . ]