User manual KOMPERNASS LERVIA KH 1150 CEILING FAN WITH HALOGEN LIGHTING

[. . . ] 12 Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Warranty and Service. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Technical Data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Importer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 IMPORTANT: Read these instructions and keep them for future reference. Study the instructions for installation and use before using the fan. 3 IB_KH1150_E2731_UK_V1. qxd 15. 01. 2007 14:47 Uhr Seite 4 1 Safety Instructions DANGER:Always follow the safety instructions below. Danger of electric shock · Only a qualified electrician may connect the device to a properly installed and earthed power line with a mains voltage from 220 - 240 V~ at 50 Hz. [. . . ] This ceiling fan is intended exclusively for use in private households. Observe all information in this installation and operating manual, in particular the safety instructions. Any other use is considered improper use. 3 Product Overview A B C D E F G H I J K L Casing Extension rod (2 variants) Connector Sliding switch for changing the direction Light module with 3 bulbs (incl. 3 halogen light bulbs) Pull chain for the light Pull chain for changing the speed Blades (5 pcs. ) Blade attachment (5 pcs. ) Blade mount (5 pcs. ) Motor housing Installation plate 5 IB_KH1150_E2731_UK_V1. qxd 15. 01. 2007 14:47 Uhr Seite 6 4 Product Description The KH 1150 ceiling fan has three speed levels that are controlled with the pull chain. The direction can be changed with a switch, allowing the fan to blow air downward or draw it up. In addition, the fan is equipped with a light with 3 halogen bulbs; the light is switched on and off with a separate pull chain. 5 Guide Section 6 describes the installation and Section 7 describes the basic operation of the KH 1150 ceiling fan. Read these sections carefully in order to perform the installation quickly and properly and to understand all the functions of the fan. The following signal words and symbols are used: DANGER Warns against possibly serious or fatal injuries WARNING Warns against possible minor injuries or possible material damage CAUTION Warns against possible defects or destruction of the product IMPORTANT / NOTE Provides important or useful information 6 IB_KH1150_E2731_UK_V1. qxd 15. 01. 2007 14:47 Uhr Seite 7 6 Installing the Ceiling Fan WARNING: Follow the safety instructions (see Section 1) to avoid injuries or damage as a result of installation errors. NOTE: The letters in parentheses refer to the figure in Section 3 "Product Overview". Required Tools Phillips head screwdriver Open-jawed spanner 8 mm 6. 1 Installing Blade mounts (J) 1 Select the desired decor: wood grain or white surface. 2 Run the lock pins of a blade mount (J) through the 3 openings of a blade (H) from below. Position the blade attachment (I) and push in the direction of the arrow (see Fig. ). The spring clip must snap in and secure the middle pin (see Fig. : circle). Mount all blades in the same way. H I J 6. 2 Installing the Extension Rod (B) 1a Long rod with plastic mount: Step 1: Loosen the side locking pin on the extension rod (see Fig. : circle). Step 3: Pull out the lock pin. 3 1 2 7 IB_KH1150_E2731_UK_V1. qxd 15. 01. 2007 14:47 Uhr Seite 8 1b If you would like to use the short extension rod, pull the mount entirely off the long rod and slide it about halfway onto the short rod, as shown. 2 Step 1: Loosen the side screws of the connector (C) so that the extension rod can be inserted. Step 3: Remove the pin. C 2 31 3 Pull the cable through the casing and place the casing onto the motor housing over the connector. DANGER: Damaged cables lead to shortcircuits. In such cases, touching the fan could be lifethreatening! Do not damage the cable when inserting the pin! 4a Step 1: Long extension rod: Pull the cable through, then insert the extension rod into the connector. Step 4: First tighten both screws evenly at the same time until hand-tight, then screw them in tightly with the screwdriver. 4b Short extension rod: After pulling the cable through (see 4a, substep 1), you must first perform the following installation step 5. 5 Install the pin and mount in reverse order from that described in step 1a and screw the locking screw into the threading of the extension rod. 1 3 2 4 8 IB_KH1150_E2731_UK_V1. qxd 15. 01. 2007 14:47 Uhr Seite 9 6. 3 Installing the Light Module (E) 1 Remove the three screws with lock washers from the light module (E). 2 Connect the cable plug of the light module to the socket on the fan. DANGER: Damaged cables lead to shortcircuits. [. . . ] Check the blade attachments Fan defective Fan runs loadly or sways significantly Blade mounts not firmly connected Blade damaged Blades not balanced out Loose blade attachment(s) Fan is not hung correctly DANGER: Disconnect the fan from the mains network before checking whether it is hung correctly. Check the fastening of the installation plate and extension rod, and correct any improper fastening Check the halogen bulbs and replace defective bulbs Light does not function Bulb defective Loose cable plug DANGER: Disconnect the fan from the mains network before checking the cable plug. Check the cable plug Do not perform any modifications or repairs on the product!Safety-relevant parts may only be repaired by an expert. 13 IB_KH1150_E2731_UK_V1. qxd 15. 01. 2007 14:47 Uhr Seite 14 10 Warranty and Service The warranty conditions and the service address can be found in the enclosed document. 11 Technical data Product: Mains voltage: Rated output: Fan Lights: Materials: Dimensions: Weight (incl. ): Labeled with testing certification: Ceiling Fan KH 1150 220 - 240 V~, 50 Hz 60 W 3 x max. [. . . ]