User manual KRUPS XN3020

[. . . ] This appliance may be used by From use for other purposes, faulty · If the cord is damaged, do not Children of at least 8 years of age, operation, non-professionals'repair or operate the appliance. As long as they are supervised and failure to comply with the instructions. Return the appliance to the Nespresso INFORMATION: when you have been given instructions about See this sign, please take Using the appliance safely and are Avoid risk of fatal electric shock representative. Correct and safe usage of your Cleaning and user maintenance · Use only an earthed cord with a Shall not be made by children unless immediately remove the plug from conductor cross-section of at least The appliance is intended to prepare they are older than 8 and they are the power socket. [. . . ] Push with the thumb and pull with the other hand to unclip to unclip your side panel as shown in the picture. Com Come and discover a wide range of side panels to style your machine in your Nespresso Boutiques or online at nespresso. CAUTION: do not change the panels when the machine is hot (wait 10 minutes after the last brewing). Place the machine on the side on a clean and smooth surface to avoid damaging your panel. Unclip the panel by rotating the Nespresso key as shown in the picture. nOTE: utilisez uniquement la clé Nespresso pour détacher vos panneaux. CAUTION: do not change the panels when the machine is hot (wait 10 minutes after the last brewing). Insert the remaining cable in the cable guide under the machine and put the machine in the upright position. Blinking light of both coffee buttons and the capsule container: heating up for approximately 25 seconds. Place a container under coffee outlet and press the Lungo button to rinse the machine. Rinse then fill the water tank with fresh drinking Voyant continu: machine prête. Close the lever and place a cup under the coffee Lift the lever completely and insert the capsule. Harm when operating the appliance During heat up, you can press the coffee button when it's still blinking. For a Latte Macchiato glass fold the cup support Press the Espresso (40 ml) or the Lungo Down again when removing the glass to avoid any automatically. Lift and close the lever to eject the capsule into the used capsule container. Automatic power off: the machine will stop automatically after 9 minutes of non use. To increase automatic power off from 9 to Refill the water tank with fresh drinking water. 30 minutes: switch the machine off, press the Empty and rinse the used capsule container and Fill the water tank and insert the capsule. To assemble the cup support and the drip tray: take off the grid, place them side by side and clip the drip tray to the cup support. CAUTION Do not use any cleaning agent or solvent cleaner to clean your panels. [. . . ] Com In case of machine pick-up, please remove the side panels and keep them safely. Your appliance contains valuable materials that can be recovered or can be recycled. Separation of the remaining waste materials into different types facilitates the recycling of valuable raw materials. Krups guarantees this product against defects in materials and workmanship for a period of two years from the date of purchase. [. . . ]