User manual PHILIPS LM801263

[. . . ] When the machine dispenses water, it produces a less loud humming sound. 7 Empty the drip tray and waste water drawer (see 'Cleaning the used capsule drawer and waste water drawer'). You can choose from a variety of coffee capsules for different types of coffee. beverages Thanks to the Dual Capsule Recognition technology, the machine automatically recognizes the capsule size and adapts the volume of your drink accordingly. [. . . ] If you do not press the coffee button, the machine programs the maximum quantity of coffee. resetting the coffee quantities To reset the coffee quantities to their factory settings: 1 Press the on/off button to switch on the machine. 3 Press and hold the ristretto , espresso and lungo buttons simultaneously Until all buttons flash quickly to show that the machine has been reset to factory settings. cleaning and maintenance Cleaning the used capsule drawer and waste water drawer Check the used capsule drawer and waste water drawer regularly. Note: For optimal hygiene, pull up the lever after use to ensure the last used capsule falls into used capsule drawer. 1 Pull the used capsule drawer and the waste water drawer out of the machine. 2 Remove the drip tray from the lower drip tray and rinse the drip tray and the cup tray under a warm tap. 6 Insert the waste water drawer with the used capsule drawer into the machine. Cleaning other parts of the machine 1 Clean the outside of the machine with a soft damp cloth. Caution: Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the machine. Warning: Do not insert a finger into the capsule compartment to avoid injury. 2 Clean the front of the machine with a soft damp cloth and clean the two parts of the coffee dispensing spout (the coffee outlets and the spout cover) under a warm tap or in the dishwasher. Note: Rinse the water tank and fill it with fresh water every 24 hours. cleaning the coffee circuit Clean the coffee circuit every week to ensure you get coffee with an optimum quality and taste. 2 Lift the lever to ensure the last used capsule falls into the used capsule drawer. 6 Open the lever and repeat steps 3 to 5 to ensure proper cleaning of the coffee circuit. Descale the machine when the ristretto and lungo button flash quickly a few times after brewing. The descaling procedure takes up to 40 minutes and consists of a descaling cycle and a rinsing cycle. Descaling is essential for the following reasons: - It prolongs the life of your L'OR Barista coffee machine - It ensures maximum cup volume - It ensures maximum coffee temperature - The machine produces less sound during brewing - It prevents malfunctioning If the descaling procedure is not performed correctly, scale residue remains behind in the machine. This causes scale to build up more quickly and may cause permanent and irreparable damage to the machine. use the correct descaler Only citric acid-based descalers are suitable for descaling the L'OR Barista machine. We advise you to use the dedicated L'OR Barista liquid descaler (CA6530). [. . . ] The machine does not switch The machine is not connected to Put the plug in an earthed wall The brewing time is longer than before. The machine does not dispense coffee or only dispenses drops of coffee. Press the button of the selected type of coffee again to continue brewing. When the cup is full, press the same button again to stop the brewing process. [. . . ]