User manual PHILIPS SENSEO CSA220/61

[. . . ] - Never put normal ground coffee or use torn pods in the pod holder, as this causes it to become blocked. - Do not use the machine in combination with a transformer, as this could cause hazardous situations. - Do not place the machine on a hotplate or directly next to a hot oven, heater or similar source of heat. - Do not use the machine at altitudes higher than 1250 meters above sea level. [. . . ] Descale the machine according to the instructions (see 'Descaling the Senseo'). Tip: before brewing coffee, preheat the cup by rinsing it with hot water or brew a coffee without coffee pod. To prevent this from happening, make sure that the sieve in the pod holder is clean and not clogged. To fully benefit from the support that Philips offers, register your product at www. 7 To start flushing, press the 1-cup button and the 2-cup button simultaneously. 8 During the flushing cycle, cold water comes out of the coffee spout. Caution: If you do not flush the machine before first use, your first coffee cup may overflow with cold water. brewing coffee 1 Fill up the water reservoir with fresh cold tap water. 3 To brew one cup of Senseo coffee, place the 1-cup pod holder with one Coffee pod in the machine. To brew two cups, place the 2-cup pod holder with two coffee pods in the machine. 4 Place the pod(s) properly in the center of the pod holder, with the convex side pointing downwards. 7 Use the Intensity Select slide to select the recipe of your choice: - Select the right position to brew a classic Senseo. 8 Press the 1-cup button to brew one cup of coffee or press the 2-cup button to brew two cups of coffee. direct Start function The Direct Start function allows you to switch on your coffee machine and brew coffee with one touch of a button. When you press the 1-cup button or the 2-cup button, this button starts flashing, the machine starts heating up and then starts to brew coffee. When the machine has finished brewing, it switches off automatically to save energy. If you have not used the machine for 1 day, you have to flush it with fresh cold water before you use it again. To flush the machine, fill the water reservoir with fresh cold water, place 2 cups under the spout and brew coffee without a coffee pod twice in a row. cleaning 1 You can clean the outside of the machine with a damp soft cloth. 3 To prevent clogging, clean the pod holders regularly with hot water, some washing-up liquid and a washing-up brush. 4 You can clean all detachable parts with hot water and some washing-up liquid or in the dishwasher. Note: Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the machine. [. . . ] start the first rinsing cycle 23 Rinse the water reservoir with fresh water. 24 Fill the water reservoir with fresh water up to the MAX indication and Place it back onto the machine. 26 Press simultaneously the 1-cup button and 2-cup button to start the first rinsing cycle. 27 The 1-cup button and 2-cup button flash simultaneously to indicate that the first rinsing cycle is in progress. [. . . ]