User manual PHILIPS SENSEO SELECT CSA240

[. . . ] - Never put normal ground coffee or use torn pods in the pod holder, as this causes it to become blocked. - Do not use the machine in combination with a transformer, as this could cause hazardous situations. - Do not place the machine on a hotplate or directly next to a hot oven, heater or similar source of heat. - Do not use the machine at altitudes higher than 1250 meters above sea level. [. . . ] Check if the sealing ring of the lid is stuck under the edge of the distribution disk. Check if you have set the Intensity Plus slide to the preferred volume setting. Tip: before brewing coffee, preheat the cup by rinsing with hot water or brew a coffee without coffee pod. To prevent this from happening, make sure that the sieve in the pod holder is clean and not clogged. To fully benefit from the support that Philips offers, register your product at www. 8 To start flushing, press the 1-cup button and the 2-cup button simultaneously. 9 During the flushing cycle, cold water comes out of the coffee spout. Caution: If you do not flush the machine before first use, your first coffee cup may overflow with cold water. brewing coffee 1 Fill up the water reservoir with fresh cold tap water. 3 To brew one cup of Senseo coffee, place the 1-cup pod holder with one Coffee pod in the machine. To brew two cups, place the 2-cup pod holder with two coffee pods in the machine. 4 Place the pod(s) properly in the center of the pod holder, with the convex side pointing downwards. 7 Slide the coffee spout up or down to adjust its height to the size of the cup you are using. 8 Use the Intensity Plus slide to select the recipe of your choice: - Select the top position to brew a classic smooth Senseo. 9 Press the 1-cup button to brew one cup of coffee or press the 2-cup button to brew two cups of coffee. direct start function The direct start function allows you to switch on your coffee machine and brew coffee with one touch of a button. When you press the 1-cup button or the 2-cup button, this button starts flashing, the machine starts heating up and then starts to brew coffee. When the machine has finished brewing, it switches off automatically to save energy. If you have not used the machine for 1 day, you have to flush it with fresh cold water before you use it again. To flush the machine, fill the water reservoir with fresh cold water, place 2 cups under the spout and brew coffee without a coffee pod twice in a row. memo function (only for types CSA250 and CSA240) For each setting of the Intensity Plus slide, you can adjust the coffee volume to your personal taste and save this setting. 1 Put the Intensity Plus slide in the position of the recipe you want to adjust. [. . . ] 8 As soon as the first descaling cycle is complete, the 1-cup button and the CALC light flash. 11 Replace the 1-cup pod holder with the 2-cup pod holder and place one Used coffee pod or a thick descaling filter in the pod holder. 13 The CALC light, the 1-cup button and 2-cup button light up in sequence to indicate that the second descaling cycle is in progress. During the second descaling cycle, the descaling solution comes out of the machine at intervals. [. . . ]