User manual ROSE DISPLAYS ANOQUICK SQUARE WITH MULTICLIPS

[. . . ] AnoQuickTM Parts Note: Use only with graphics mounted on 3/16" foamboard or other similar thickness. Can also use a folded edge thinner substrate. Square Profile Instruction Sheet AnoQuick 12A300SQ MultiClips 1UP-0101 End Caps 06-5545 Instructions For Hanging Step 1 Prepare edges of graphic. Using the AnoQuick holder, run it across the graphic edge, crushing it slightly. [. . . ] Using the AnoQuick holder, run it across the graphic edge, crushing it slightly. 1 Step 2 Starting at one corner, push the holder onto the graphic. Work your way down the holder tapping it down firmly to seat the graphic fully. 2 Figure 1 Figure 2 Step 3 Squeeze sides of MultiClip together. Fig. 3 Step 4 Align the bottom rail of the MultiClip with the top channel of the aluminum holder. 4 Repeat steps 3 & 4 for second MultiClip. Figure 3 Step 5 Push end caps into place. 6 Important note: Please save and reuse the AnoQuick holder, End Caps and MultiClip for future projects. Figure 5 Figure 6 AnoQuick is a trademark. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSAnoQuickSQMC 35 Congress Street, Salem, MA 01970 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-7. 31. 02 AnoQuickTM Parts Note: Use only with graphics mounted on 3/16" foamboard or other similar thickness. Can also use a folded edge thinner substrate. Square Profile Instruction Sheet AnoQuick 12A300 MultiClips 1UP-0101 End Caps 06-5545 Instructions For Hanging Step 1 Prepare edges of graphic. Using the AnoQuick holder, run it across the graphic edge, crushing it slightly. 1 Step 2 Starting at one corner, push the holder onto the graphic. Work your way down the holder tapping it down firmly to seat the graphic fully. 2 Figure 1 Figure 2 Step 3 Squeeze sides of MultiClip together. Fig. 3 Step 4 Align the bottom rail of the MultiClip with the top channel of the aluminum holder. 4 Repeat steps 3 & 4 for second MultiClip. Figure 3 Figure 4 Step 5 Push end caps into place. [. . . ] Fig. 3 Step 4 Align the bottom rail of the MultiClip with the top channel of the aluminum holder. 6 Important note: Please save and reuse the AnoQuick holder, End Caps and MultiClip for future projects. Figure 5 Figure 6 AnoQuick is a trademark. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. [. . . ]